Loading ...
Loading ...
Loading ...
9
3. To use the nozzle without the brush, press the release
button and slide the brush up (Fig. 9).
mWARNING! Do not adjust the 2-in-1 nozzle + brush
attachment while the tool is switched on. Doing so could result
in injury.
Operation Tips
mWARNING! Use the cordless handheld vacuum only in
daylight or good articial light.
• Make sure the dust tank with the HEPA lter is properly
installed and secured when using. Failure to properly
secure the assembly could cause the dust tank and the
HEPA lter to release from the equipment.
• Double check to make sure the HEPA lter is not broken
or torn. Do not use lter that are broken or torn. Handle
the lter carefully when removing and installing.
• This unit is intended for indoor use only. Do not use this
unit outdoors.
• Be extremely careful when working on slopes and stairs.
• Clean up after using the handheld vacuum. Dispose of
debris appropriately.
mWARNING! To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Basic Vacuuming Procedure
• Always hold the unit on the handle when the vacuum is
on.
• During vacuuming, keep the nozzle at a distance of
approximately 0.4 inch (1 cm) above the material to be
vacuumed.
NOTE: The cordless handheld vacuum is equipped with
working overheating protection. When the temperature is
too high during vacuuming, the circuit will cut o and the
vacuum will stop working. If this happens, DO NOT press
the On/O button any more. Let the vacuum cool down
for a while before resuming working.
• Turn o the unit after vacuuming, before cleaning and
maintenance. Empty the dust tank, clean and dry the
inside and outside before storage.
• Empty the dust tank outside in order to avoid a mess.
• Clean or change the lter (see Maintenance section) if the
suction performance deteriorates.
mWARNING! Never remove the dust tank without rst
switch o the equipment.
Maintenance
To order genuine replacement parts or accessories for the
Sun Joe
®
AJV1000 cordless handheld vacuum, please visit
sunjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
Cleaning The Dust Tank
1. Take the unit outside to clean it to avoid creating a mess
indoors.
2. Remove and empty the dust tank. Clean the tank with
water and allow it to dry completely.
Cleaning/Changing The Filter
The HEPA lter included is made of high quality material
designed to stop small dust particles. The lter should be used
for dry pick-up only. Handle the lter carefully when removing
it for cleaning and replacing. Check the lters for tears or
small holes, a small hole can let dust pass through and out of
the cleaner. Do not use a lter with holes or tears, replace it
immediately.
1. Remove and empty the dust tank. Lift the HEPA lter up
from the dust tank.
2. Clean the lter by gently tapping or brushing dirt o.
3. If needed, rinse the lter with clean water. Allow the lter
to air dry for 24 hours before installing onto the vacuum.
4. If the lter is torn and cannot be used anymore, insert a
new lter into the dust tank and attach the dust tank onto
the vacuum (Fig. 7).
Fig. 8
2-in-1 nozzle + brush attachment
Fig. 9
Nozzle Brush
Release button
Loading ...
Loading ...
Loading ...