Loading ...
Loading ...
Loading ...
7. Operating Instructions
– 11 –
EN
7.2 Raising a Load
1. Position the jack directly beneath the approved
vehicle lifting point.
See the vehicle manufacturer information for the
approved lifting points.
2. Twist the handle shaft (1) clockwise until strong
resistance is felt.
3. Pump the handle shaft down and up until contact is
made with the vehicle and check that the saddle (4) is
positioned correctly.
4. Pump the handle shaft down and up to lift the vehicle.
Use the full stroke range to lift more quickly.
Important: If the jack drops under load, safely lower
the load (see 7.3) and bleed the piston chamber
(see 7.1).
5. Immediately secure the raised vehicle with an
appropriate axle stand, placing it as instructed in the
manufacturer information.
7.3 Lowering a Load
WARNING! Always ensure that there are no persons or
obstacles beneath the vehicle before lowering.
1. Gently pump the handle shaft (1) to raise the vehicle
slightly and allow the axle stand to be removed safely.
2. When the axle stand is clear, carefully twist the pump
handle anticlockwise to gently lower the load.
Do not turn the handle shaft more than a half turn at
a time during lowering.
3 Fig.
Pumping the handle shaft down and up raises the lifting
arm if the release valve is closed (Fig. 3).
Loading ...
Loading ...
Loading ...