Loading ...
Loading ...
Loading ...
11
Looper
You can record up to 32 seconds (MONO) of a performance and play back the recorded section over and over. You can also layer
additional performances with the recording as it plays back (overdubbing).
This lets you create real-time backing performances on the y.
Press the [
H
] switch and [CTL1] switch simultaneously to turn on the Looper.
Record
Recording will start
immediately when you press
the [CTL1] switch.
At the point where you want
to loop, press the pedal to
switch to playback.
Loop Playback
Play back the loop.
Pressing the [CTL1] switch will
switch to overdubbing.
Overdub
Record additional layers while
playing back the loop.
Press the [CTL1] switch to
switch to playback.
Stop/Clear
To stop, press the [CTL1] switch
twice.
To clear the phrase, hold down
the [CTL1] switch for at least two
seconds while stopped.
Press Twice
Loop Playback Level Setting
If you set the playback level at 100 (default value), the volume of the
performance and that of the loop playback will be identical.
If you set the playback level to a value lower than 100, the volume of
the playback will be lower than that of the performance. As a result, the
sound of the performance won’t get buried by the loop playback sound,
even if you record a multiple number of times.
1. Choose [MENU]
0
“LOOP.”
2. Adjust the value of “LEVEL” with the [1] knob.
[CTL1] Switch Color
Color Status
Red Recording/Overdub
Blue Playback
Blue (blink) Stopped (phrase exists)
Unlit Stopped (no phrase)
MEMO
* The recording time is 32 seconds (MONO).
* The recorded content will be lost when you turn o the Looper or turn
o the power.
* The settings for CTL1 saved in patches will be ignored while the Looper is on.
Error Message List
Display Problem Action
USB OFFLINE!
Transmissions from the connected device
have been interrupted. This message also
appears when the power to the connected
device has been turned o. It does not
indicate damage.
Check to make sure no cable is disconnected and that there are no shorts.
DATA WRITE ERROR!
Writing to the memory for storage of user
data failed.
The unit may be damaged. Consult the nearest Roland service center.
OUT OF RANGE! SET AGAIN The [EXP] pedal cannot be calibrated.
Conrm the calibration by carrying out the procedure once more (p. 9).
If the message continues to appear even after the calibration is correctly
performed, it may indicate damage or malfunction. Consult your Roland dealer
or contact Roland Service Center.
KNOB IS LOCKED! The knobs are locked. Turn “KNOB LOCK” o. For details, refer to the “GT-1 Parameter Guide” (PDF le).
BATTERY LOW! Batteries are low. Replace them with new ones.
Loading ...