Loading ...
Loading ...
Loading ...
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes
Toensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely Use
the correct tools as necessary to insure proper tightness
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier Standard
wrench sizes are listed
(1) 3/4 wrench Pliers
(1) 1/2 wrench Tire pressure gauge
Utility knife
When right or left hand ismentioned in this manual, itmeans
when you are in the operating position (seated behind the
steering wheel)
TO REMOVE TRACTOR FROM CAR-
TON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton
• Cut along dotted lines on all four panels of carton
Remove end panels and lay side panels flat
• Check for any additional loose parts or cartons and
remove
BEFORE REMOVING TRACTOR FROM
SKID
ATTACH STEERING WHEEL (See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
• Slide extension shaft onto lower steering shaft
• Place tabs of steering boot over tab slots in dash and
push down to secure
INSTALL STEERING WHEEL
• Position front wheels of the tractor so they are pointing
straight forward
• Remove steering wheel adapter from steering wheel
and slide adapter onto steering shaft extension
• Position steering wheel so cross bars are horizontal
(left to right) and slide inside boot and onto adapter
• Assemble large flat washer 5/16 lockwasher, 5/16 hex
bolt and tighten securely
• Snap steering wheel insert into center of steering
wheel
• Remove protective materials from tractor hood and
grill
IMPORTANT: CHECK FORAND REMOVEANY STAPLESIN
SKIDTHATMAYPUNCTURETIRESWHERETRACTORISTO
ROLLOFF SKID
FLAT
WASHER
STEERING STEERING
WHEEL
BOOT
ADAPTER _"J_
L EXTENSION
SHAFT
LOWER
STEERING
SHAFT
\ " _ _/_ SLOTS
FIG. 1
INSTALL SEAT (See Fig. 2)
Adjust seat before tightening adjustment knob
• Remove adjustment knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor
• Pivotseat upward and remove from the cardboard pack
ing Remove the cardboard packing and discard
• Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan
• Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor
• Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely Do not tighten
• Lower seat into operating position and sit on seat
• Slide seat until a comfortable position is reached
which allows you to press clutch/brake pedal all the
way down
• Get off seat without moving its adjusted position
• Raise seat and tighten adjustment knob securely
6
Loading ...
Loading ...
Loading ...