Loading ...
Loading ...
Loading ...
24
- Ensure that all regulations concerning the discharge of exhaust air have been
fulfilled before you use the appliance.
Before performing any cleaning or maintenance operations, disconnect the ap-
pliance by unplugging it or using the main switch. The manufacturer disclaims
all liability for any damage that may be directly or indirectly caused to people,
things and animals due to the failure to follow all the instructions provided in
this booklet and above all the warnings relating to the installation, operation
and maintenance of the appliance.
WARRANTY
N
The new equipment is covered by warranty. The warranty conditions are pro-
vided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting
from printing or transcription errors. The manufacturer reserves the right to
modify its products as it considers necessary or in the interests of the user,
without compromising their essential safety and operating characteristics.
O
ASSEMBLY INSTRUCTIONS FOR
WALL-MOUNTED RUSTIC HOOD
Step 1
- Rest the support batten (A-Fig. 1) against the wall at a height above the hob
determined by the sum of the values X+Y+265 mm.
- Use a spirit level to make sure it is perfectly horizontal and make 2 marks at
the ends of the batten where the 2 holes are to be drilled.
- Drill the holes, insert the two ΓΈ 8mm screw anchors and fasten the batten
using the relevant screws.
Step 2
- Hook the hood onto the support batten (Fig. 2).
Step 3
- Adjust the alignment of the hood using the screws on the brackets (Fig. 3).
The upper screw (B) is used to adjust the distance from the wall, and the lower
screw (C) the vertical sliding
Step 4
- In order to prevent the hood from unhooking owing to pressure from under-
neath, fasten it to the wall with a screw anchor and relevant screw inserted in
the appropriate hole (Fig. 4).
ASSEMBLY INSTRUCTIONS FOR
CORNER HOODS WITHOUT BAR
Step 1
- Undo the rear metric screw (A) and remove the motor from the bottom of
the hood (fig. 1).
- Check the horizontal alignment with a spirit level and mark the 4 holes to be drilled.
- Drill the holes, insert 2 x 8mm dia. screw anchors and fix the hood in the desired
Loading ...