Loading ...
Loading ...
Loading ...
18
connect the battery, slide the battery pack fully forward. Until the latch locks into
place.
To remove the battery pack
Press the battery release button ,Slide the battery pack backward, and then pull or
lift the battery out of the tool .
WARNING:
Follow these instructions in order to avoid injury and to reduce the risk of electric
shock or fire:
• Replace the battery pack or the charger immediately if the battery case or
charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or
performing maintenance on any part of the power tool.
• Read, understand, and follow the instructions.
CONNECTING CHARGER TO POWER SUPPLY
Power supply(mains) voltage and operating
voltage must be the same.
Insert the plug in the wall outlet.
A self test is performed after the charger is
connected to the power supply. During this
process, the green light(1) on the charger
lights up.
CHARGING THE BATTERY
A factory-new battery is not fully charged.
Recommendation: Fully charge the battery before using it for the first time.
Insert Connect the charger to the power supply - mains voltage and operation
voltage of the charger must be the same - see “Connecting Charger to Power
Supply”.
Operate the charger only in enclosed and dry rooms at ambient temperatures
between +5℃ to +40℃(+40 ℉ to 104℉)
Only charge dry batteries. Allow a damp battery to dry before charging.
Loading ...
Loading ...
Loading ...