Dewalt DWX723 Instructional Manual

Loading ...

English

3. When the front edge of beam and locator clip are engaged,

a slight downward pivot will allow secure engagement of the

release levers to the back of the beam. Follow same procedure

with second mounting bracket at the appropriate position on

the beam for the size of the plywood.

4. Place plywood onto mounting brackets and align drilled holes

with slots in mounting brackets. Refer to DW7231 Hardware

Selection Chart and use either Method 1 or 2 to secure ply-

wood to mounting brackets.

5. Use 1/2" (13mm) wrench to tighten hardware.

6. The miter saw should be mounted to plywood using holes in

the miter saw base. The hardware size will be determined by

the holes in the miter saw base. Hardware should be 1-1/4"

(31.8 mm) longer than the maximum height of the miter saw

base at each mounting location.

a. Transfer location of mounting holes from miter saw base to

plywood.

b. Drill holes accordingly to the size of the hardware chosen.

NOTE: Hardware must be purchased to mount miter saw to

plywood. All purchased hardware should be a minimum of

Grade 5 or Class 8.8.

c. Secure miter saw to plywood as shown in Figure 9. Saw base

(P), 3/4" (19 mm) plywood (T), flat washer (Q), lock washer (S)

and nut (R).

NOTE: Ensure a flat washer (Q) is used between plywood (T)

and lock washer (S).

d. Tighten all hardware.

Carry Strap

If you purchase the carry strap accessory for DEWALT stands, use

the square hole in the metal end to mount the accessory.

WIDTH OF SAW + 4" (101.6mm)

1" (25.5mm)

3/8" (9.5mm)

DIAMETER

HOLES, ALL

4 CORNERS

2" (50.8mm)

MINIMUM BOTH

SIDES

15"

((381mm)

BOTH

SIDES

MINIMUM OF

16" (406.4mm)

MUST BE AT

LEAST AS DEEP

AS THE SAW

BEING MOUNT-

ING

1" (25.5mm)

MOUNT MITER

SAW IN SHADED

AREA

FIG. 8

FIG. 9

Loading ...

Dewalt DWX723 Heavy Duty Miter Saw Stand

Instructional Manual - Page 7