Loading ...
Loading ...
Loading ...
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling.
C
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
Technical data
on page 17
.
WARNING: An incorrectly attached
cutting attachment can result in injury or
death.
To install the suspension ring if applicable
1. Install the suspension ring between the arrows on
the rear handle and the loop handle.
Note: Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
Assembly of trimmer heads
WARNING: When you install the
cutting attachment it is very important that
the raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
WARNING: Never use a cutting
attachment without an approved guard. See
the chapter on Technical data. If an incorrect
or faulty guard, or the J-handle is missing
when using metallic cutting attachment, is
fitted this can cause serious personal injury.
To attach the trimmer guard for a trimmer
head
1. Hang the trimmer guard (A) onto the two hooks on
the plate holder (M).
2. Bend the guard around the shaft and attach it with
the bolt (L) on the opposite side of the shaft.
3. Put the locking pin (C) in the groove on the bolt head
and tighten the bolt fully.
L
A
M
C
785 - 006 - 13.02.2023
11
Loading ...
Loading ...
Loading ...