Loading ...
Loading ...
Loading ...
11
10. Specications
Type Condenser, externally polarized
Acoustical operating principle Pressure gradient transducer
Diaphragm 3 micron gold sputtered Mylar
Transducer Ø 25.4 mm, 1 in
Polar pattern Cardioid
Sensitivity 27.4 mV/Pa, -31.2 dBV/Pa
Signal / noise ratio 87 dB (A)
Dynamic range 133 dB (A)
Equivalent noise level 7 dB (A)
Max. SPL for 0.5 % THD 140 dBSPL
Supply voltage 48 V +/- 4 V
Current consumption 2.63 mA
Internal impedance 110 Ω
Rated load impedance 1,000 Ω
Connector Gold plated 3-pin XLR
Mic enclosure Zinc die cast
Microphone dimensions 138 x 52 x 36 mm, 5.43 x 2.04 x 1.42 in
Microphone net weight 310 g, 10.9 oz
Table 10.1
Microphones measured according to: IEC 60268-4
Phantom power according to: IEC 61938
Noise measurement according to: IEC 60268-1
11. Accessories
// LCT 40 SH - shock mount
A shock mount is recommended for most recording applications as it reduces
unwanted structure-borne noise. The open front of the shock mount allows you
to position the microphone as close as you like to the source.
// LCT 50 PSx - magnetic pop lter
The magnetic pop lter was designed to perfectly integrate with the design of the
microphone and its shock mount. A pop lter not only helps to avoid plosives and
hisses on your recording, but also protects the condenser capsule from being
exposed to moisture.
// LCT 40 Wx – windscreen
This one is especially useful when using the microphone outdoors, to shield the
capsule from wind. Can also be used for vocal recordings, to protect the capsule
from moisture.
// DTP 40 Lb - transport bag
Microphones which are not in use should not remain on the stand gathering dust
or be unnecessarily exposed to humidity. Unmount it from the shock mount and
put it into the supplied DTP 40 Lb transport bag.
// DTP 40 Mts - Mic mount (optional)
Rubber microphone mount. Provides rm grip and attenuates structure-borne
noise. Compatible with 3/8“ and 5/8“ threads.
Loading ...
Loading ...
Loading ...