Loading ...
Loading ...
Loading ...
3. Put the wet items oil top of the rack. leave space between the items so air can reach all
the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
4. Close the door.
5. Select a Manual cycle, and choose a temperature or Air Only (see following chart). Items
containing foam, rubber or plastic must be dried on a clothesline or by using the Air Only
temperature setting.
6. You must select a time by pressing the MANUAl. DRY TIME i- or +) buttons. Reset time as
needed to complete drying. Refer to the following table.
7. Press (and hold) HOlD TO START button (about 1 second).
NOTE: You must remove rack for normal tumbling. Do not use automatic cycles with the
drying rack.
This chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting and drying time. Actual drying time will depend on the amount of
moisture items hold.
Rack Dry Setting Temp. Time*
Wool Sweaters limed Dry low 60
Block to shape and lay flat on the rack
Stuffed toys or pillows Timed [Dry I.ow 60
Cotton or polyester fiber filled
Stuffed toys or pillows Timed [Dry Air Only 90
Foam rubber filled (no heat)
Sneakers or canvas shoes limed [Dry Air Only 90
mo heat)
*(Minutes) Reset time to complete drying, if needed.
{_{_ii!_1!!ii_i!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!!!iiii!i_'!'i_i_!i_i_!_!_!_!_!_!_!_¸ ,_i_ _iiii!i_!!!!!!i_!!!!!!i_i_i!!!_:_!!_ii!:_ii!_E!_!_!_!_!_!_!_!_!_!_i_:_ii!!_!_!_!_!_!_!_!_!_!_!_!_!_!_!_!_{_i_:_!i;
DRYER CARE
Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Every load cleaning
The lint screen is located in the door opening of the dryer. A screen blocked by lint can
increase drying time.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with your fingers. ]Do not rinse or
wash screen to remove lint. Wet lint is hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
• If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint. See "Venting Requirements."
Loading ...
Loading ...
Loading ...