Loading ...
Loading ...
Loading ...
4
13
11
Install the wick to the wick sleeve according to the allo-
wed direction engraved on the wick sleeve.
12
Install the wick sleeve (with wick) to the primary air
tube. And then turn the wick sleeve clockwise to set in
the handle arm.
13
Install the bracket. Then tighten the screw which is hol-
ding the stem.
14
Put the wick holder chassis back into position.
15
Screw the four wing nuts hand tight.
16
Place the knurled wick adjustment knob on the wick
mechanism. Turn the knob as far to the right as possi-
ble. Press the tip-over switch. Check that the wick can
be lowered completely. Repeat this check a number of
times. If the wick cannot be lowered completely it has
not been placed correctly. If this is the case, repeat the
procedure from No. 12. Pull the knurled wick adjust-
ment knob off the heater.
17
Put the cabinet back into position and tighten the three
screws. Tighten the screw to fix the handle of “dyna-
mo” by holding the handle. Put the knurled wick
adjustment knob back into position. Now put the com-
bustion chamber back into position. Check that it is
level by sliding it slightly to the left and the right by its
handle. Close the grill.
18
Put the filled removable tank into position. Wait 30
minutes after replacing the tank before using the heat-
er.
12a
16b
17c
18
16a
14
15
17b
17e
11b
11a
17a
17d
13b
13a
12b
Loading ...
Loading ...
Loading ...