Loading ...
Loading ...
Loading ...
Problem
Whitefilmoninside
surfaces
Beforeyoucall forservice...
_ Troubleshooting -tips
Possible Causes
Hard water minerals
What ToDo
* GE i'ecomn_ends JetDIg ®Dishwasher Cleaner to hel I)
remove some haM water and minteral stains.
" For extreme staining, clean tile interior by appl)ing
dishwasher deteigent to a damp sponge. Wear rubber
gloves. Do not use any type of cleanser other than those
recommended or dishwasher (leteigent because it may
cause fi,amin , or sudsing Cascade, ®Cascade Complete ®
and Electrasol ®Automatic Dishwashing Detergents have
been approved fi)r use in all GE dishwasheI_.
Dishes don't dry Low hflet water temperature " Make sure inlet water temperature is correct (see Usit7g the
dishwasher section).
" Select HEATEDDRY.
Rinse agent dispenser is empty • Check tile rinse agent dispensei:
Dishwasher won't run Fuse is blmm, or the * Replace fllse or reset circuit breakei: Remove any other
circuit breaker tripped appliances fl'om tile circuit.
• TIT resetting tile START/RESETpad.
Wall switch (some installations) * Check for a wall switch that tile dishwasher might be
is in the "off" position connected to. A wall switch is requiied by electrical codes
in some localities. Turn tile switch "on" if it is "off."
Steam This is normal • SteaIn coines through tile vent by tile door latch during
(h?'ing and when water is being pumped out.
Sanitized light does The door was opened mzd the * Do not interrupt tile cycle anytime during or alter
not illuminate at the cycle was interrupted during main wash.
end ofthe cycle or after the main wash portion
(Anti-Bacteria
The incoming water • Raise tile water heater teinperature to 120°F.
cycle only)
telnperatttre was too low
IC
Loading ...
Loading ...
Loading ...