Loading ...
Loading ...
Loading ...
Materials Needed
• Y4"outer diameter flexible copper tubing
• Shut-off valve (requires a '/#' hole to be drilled into
water supply line before valve attachment}
• Adjustable wrench
• '/4" hex nut driver
Note
.
.
.
Add 8' to tubing length needed to reach water
supply for creation of service loop.
Create service loop with copper
tubing (minimum 2' diamete0.
Avoid kinks in the copper tubing
when bending the service loop.
Do not use plastic tubing.
Remove plastic cap from water valve ._ o
inlet port.
Place brass nut (A} and sleeve (B} on
copper tube end as illustrated. (Do not
use old sleeve.} Brass nut (A} and
sleeve (B} are provided A
in the refrigerator Use
and Care guide packet.
Place end of copper
tubing into water valve
inlet port. Shape tubing
slightly. Do not kink - so that tubing
feeds straight into inlet port.
5. Slide brass nut over sleeve and screw nut
into inlet port. Tighten nut with wrench.
UMPORTANT: Do not overtighten. Cross
threading may occur.
Pu[[ on tubing to confirm connection is
secure. Connect tubing to frame with
water tubing clamp (C} and turn on
water supply. Check for leaks and
correct if necessary. Continue to observe .........
the water supply connection for two to
three hours prior to moving the
refrigerator to its permanent location.
Monitor water connection for 24 hours.
Correct leaks, if necessary.
Handme installation
If not installed, the handle is located in the interior or
attached to the back of your refrigerator. Remove and
discard handle packaging and tape.
Handle design varies from refrigerator to refrigerator.
Please reference the appropriate instructions for your
model.
Front Mount Nandle
Materials Needed
Gloves to protect hands
Phillips screwdriver
Plastic door removal card (or '/32"thick plastic card},
retain the card for future use°
To Unstall:
1. The handles are to be oriented
as shown.
Align front mount door handle
clip with the door tabs.
Ensure the handle clips are
positioned slightly above the
door tabs.
Door
Tab ....
/4. Rotate the
handle so that the handle is flat
against the door.
5. Push the handle down against the
upper door tab just enough to allow
it to hang unsupported.
Loading ...
Loading ...
Loading ...