Loading ...
Loading ...
Loading ...
Setting Surface Controls
Operating the Dual Surface Radiant Element
The cooktop is equipped with a dual radiant
surface element located at the right front (See
Figures 1 & 2) positions. The unit control knob has
a dual set of graduations. For small utensils use the
right side of the control knob (figure 3); for larger
utensils the left (figure 4). Only the inner surface of
the unit heats when using it for small utensils; the
whole surface heats for large utensils. You may
switch between settings at any time during cooking.
Figure 1
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface element.
2. Push in and turn the control knob counterclockwise (See Figure 3)
for smaller cookware or clockwise (See Figure 4) for larger
cookware.
3. Turn the knob to adjust the setting if needed. Start most cooking
operations on a higher setting and then turn to a lower setting to
finish cooking. Each surface element provides a constant amount of
heat at each setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the cookware is
too small for the surface heating area.
4. When cooking has completed, turn the surface control knob to
OFF before removing the cookware. Note: The Surface indicator
light will come on when the control knob is turned on and will
continue to glow until the glass cooktop has cooled down to a
moderate level. The light may remain on even though the controls
are turned OFF.
Note: See previous page for table of recommended control settings.
Figure 2
Figure 3 Figure 4
Single Setting Dual Setting
Dual Radiant heating areas on ceramic
smooth top (shown in black)
10
Loading ...
Loading ...
Loading ...