Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/17296437-nvr608rh-64-xi/bg151.png)
Parameter Description
NIC Member
When the network mode is Fault Tolerance or Load Balance, you need
to select the checkbox to bind NIC cards.
●
Make sure that at least two NIC cards are installed.
●
NIC cards using dierent ports such as optical port and electrical port
cannot be bound together.
●
After binding NIC cards, you need to restart the Device to make the
change eective.
IP Version Select IPv4 or IPv6. Both versions are supported for access.
MAC Address Displays the MAC address of the Device.
DHCP
Enable the system to allocate a dynamic IP address to the Device. There is
no need to set IP address manually.
●
If you want to manually congure the IP information, disable the DHCP
function rst.
●
If PPPoE connection is successful, the IP address, subnet mask, default
gateway, and DHCP are not available for conguration.
IP Address
Enter the IP address and congure the corresponding subnet mask and
default gateway.
●
The IP address and default gateway must be on the same network
segment.
●
Click Test to check whether the IP address is available.
Subnet Mask
Default Gateway
MTU Displays the MTU value of the NIC card.
Step 3 On the TCP/IP page, congure the DNS server.
This step is compulsive if you want to use the domain service.
●
Obtain DNS server automatically.
When there is DHCP server on the network, you can enable DHCP so that the Device
can automatically obtain a dynamic IP address.
●
Congure DNS server manually.
Select the IP version, and then enter the IP addresses of preferred and alternate DNS
server.
Step 4 Select a NIC card as the default card.
Step 5 Click Apply.
User's Manual
323
Loading ...
Loading ...
Loading ...