Loading ...
Loading ...
Loading ...
7
Set Screw
Hairpin Clip
Clevis Pin
Clevis Pin
Brown, Blue, Red, Gray,
Yellow wires and safety
cable
Downrod
Pin
Hanger Ball
1. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 6. (Figure 1)
Figure 1
3. Loosen the two set screws in the downrod support
of the motor assembly. Route the brown, blue, red,
gray, yellow wires and safety cable through the
downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Figure 2
Figure 3
Figure 4
Downrod
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
Set Screws and
Locking Nuts (2)
Hairpin Clip
Downrod
How to Assemble Your Ceiling Fan
Set Screws (2)
Loading ...
Loading ...
Loading ...