Loading ...
Loading ...
Loading ...
7
For vented installations only
1. Fit vent system over the exhaust outlet.
2. Measure from the bottom of the air deector to the bottom of
the hood outlet. Cut the ductwork at the measured dimension.
Dimension
to measure
Roof outlet
Wall
outlet
3. Seal connection with clamps.
4. Check that back draft dampers work properly.
Electrical Connection
WARNING: Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove terminal box cover.
3. Remove the knockout in the terminal box cover and install a
UL listed or CSA approved
1
⁄2” strain relief.
4. Run home power supply cable through strain relief, onto
terminal box.
A
B
C
D
E
A. UL listed cable connectors
B. White cables
C. Black cables
D. Green (or bare) and yellow-green ground
wires
E. Household power cable
5. Use UL listed wire connectors and connect black wires
together.
6. Use UL listed wire connectors and connect white wires
together.
WARNING: Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire in
terminal box. Failure to do so can result in death or electrical
shock.
7. Connect green (or bare) ground wire from home power supply
to yellow-green ground wire (F) in terminal box using UL listed
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Reconnect power.
Install duct covers
• When using both upper and lower vent covers, push lower
cover down onto hood and lift upper cover to ceiling and
install with two mounting screws.
NOTE: For vented installations, the upper vent cover may be
reversed to hide slots.
C
A
B
C
D
A. Upper vent cover
B. Lower vent cover
C. 4 x 8 mm screws
D. Bracket
NOTE: To prevent scratches, lay paper or a kitchen towel over
the edges of the lower ue ductto protect the surface.
Complete Installation
• For non-vented (recirculating) installations only, install
charcoal lters over metal grease lter.
• See the "Maintenance" section.
• Install metal lters. See the "Maintenance" section.
To get the most efcient use from your new range hood, read the
"Maintenance" section.
Keep your Use, Care and Installation Guide close to your range
hood for easy reference.
1. Fix the wiring conduit of the hood.
2. Slide the hood back against the cabinet. Tighten the mounting
screws. Be sure the screw heads are in the narrow neck of the
keyhole slot.
3. Drive 2 pieces of the selected screws in the lower security
screws location (see the image below).
Loading ...
Loading ...
Loading ...