Loading ...
Loading ...
Loading ...
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
Sanitize ]
Tosanitize your dishes and
glassware in accordance
with NSF/ANSl Standard
184 for Residential
Dishwashers.
Raises the water temperature in the final rinse to
approximately 155°F (68°C). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSl Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize or Sani Rinse option adds heat and time to the
cycle.
Normal Wash cycle.
Heavy Wash cycle
automatically uses
Sanitize. Only these
sanitization cycles have
been designed to meet
the NSF/ANSl
requirements.
For best drying results, dry Turn OFEwhen loads contain plastic dinnerware that may be A!l Cyclesl Automatic
H_rtyd_ dishes with heat. sensitive to high temperatures, with all wash cycles
.............................................. This option With the use of rinse aid Will provide the best ...... un!ess Y0U turn !t off: ......
drYing performance ............................
4 Hour
Delay ]
To run your dish washer at Delays the start of a cycle up to 4 hours.
a later time or during off- Select a wash cycle and options. Press 4 Hour Delay. Press
peak hours. START/RESUME. Close the door firmly.
All cycles.
,ok To avoid unintended use of To turn on Lock, press and hold Heated Dry for at least
your dishwasiqer, or cycle 4 seconds.
Heated_L_ry and option changes during To turn off Lock, press and hold Heated Dry for at least
a cycle. 4 seconds.
When Control Lock is lit. all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
3 times. The dishwasher door can be opened while the
controls are locked.
Anytime
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROL PURPOSE COMMENTS
To start or resume a If the door is opened during a cycle or the power is interrupted, the StarVResume indicator
Start/ wash cycle flashes. The cycle will not resume until the START/RESUME button is pushed and the door is ....
Resume closed within 3 secondsl
To cancel wash
Cancel cycle
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
: i Tofolowthe The Clean indicator glows When a cYC e is f n shed.
Z Sk-a°n_iirz°_d°oK progress of you[ If you Select the sanitize option; When the sani Rinse CYcie is finished, the sanitize indicator
alsnwasner cycle
m C'ean glowsl If your dishwasher did not proper!y sanitize your dishes, the light flashes at the end ofthe
cycle, This can happen if the cycle is interrupted, or the wate[ could not be heated to the required
Loading ...
Loading ...
Loading ...