Loading ...
Loading ...
Loading ...
43 - English
Look for these accessories where you purchased this product or call 1-800-525-2579:
Stand Assembly ..........................................................................................................................................089240046001
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.
ACCESSORIES
MAINTENANCE
Fig. 58
DUST
CHUTE
SCREW
DUST CHUTE
See Figure 58.
This saw features a dust chute for convenience in discharging
sawdust. A standard shop vac can be attached to the chute,
located under the back side of the saw.
During periods of extended use, the dust chute should be
emptied and cleaned to prevent buildup of sawdust and to
make sure there are no obstructions or other small offcuts
that may have fallen into the throat plate opening that could
hinder maximum performance.
To clean the dust chute:
Unplug the saw.
Loosen the screw at the bottom of the dust chute.
Remove the cover.
Shake out any sawdust and wipe with a clean dry cloth,
as needed.
Replace the cover and securely tighten the screw.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Excess vibration. Blade is out of balance.
Blade is damaged.
Saw is not mounted securely.
Work surface is uneven.
Blade is warped.
Replace blade.
Replace blade.
Tighten all hardware.
Reposition on flat surface. Adjust legs of
optional stand.
Check saw blade installation. Replace
blade if necessary.
Rip fence does not move smoothly. Rip fence not mounted correctly.
Rails are dirty or sticky.
Clamp screw is out of adjustment.
Remount the rip fence.
Clean and wax rails.
Adjust clamp screw counterclockwise.
Rip fence does not lock at rear. Clamp screw is out of adjustment. Adjust clamp screw clockwise.
Loading ...
Loading ...
Loading ...