Loading ...
Loading ...
Loading ...
10
| Getting Started
Napoleon.com | BUILT-IN Series
Getting Started
306 mm
465 mm
M
AXIMUM
C
YLINDER
D
IMENSIONS
WARNING! Close the individual shutoff valve to isolate the grill from the gas supply piping system during any
pressure testing equal to or less than ½ Psi (3.5 kPa).
WARNING! Check the hose for evidence of excessive abrasion, melting, cuts or cracks. If the hose is damaged,
it must be replaced with an assembly specifically recommended by Napoleon.
If Placing the Cylinder in a Built-in Enclosure
• The design of the enclosure should allow for the gas cylinder to be connected, disconnected, and the connections inspected
and tested outside of it. The connections that could possibly be disturbed when installing the cylinder in the enclosure can
be leak tested inside.
• The cylinder must be isolated from the grill enclosure, and protected from radiation, flames, hot drippings, and other foreign
or hazardous materials.
• A door on the enclosure to access the cylinder is acceptable if it is non-locking and can be opened without using tools.
• There must be a minimum clearance of 51mm between the floor of the cylinder enclosure and the ground.
• The cylinder compartment(s) shall have permanent openings ventilating directly to the outside of the appliance and
consisting of either of the following:
A) Perforations, uniformly distributed over the height of the enclosure and with a total free area of not less than 25%
of the sidewall area.
B) Separate openings at high and low level, such that -
(I) the total free area at high level (Opening A) is not less than 20 000mm
2
and is within 125 mm oft he top of
the cylinder compartment; and
(II) the total free area at low level (Opening B) is not less than 20 000mm
2
; and
A) At least 25% of the required area is within 15 mm of the base of the cylinder compartments;
B) The total required area is within 125 mm of the base of the cylinder compartment; and
C) The openings cannot be obstructed by the cylinder(s).
Ope
ni
ng
A
Opening
B
125 mm
MAX.
864 mm
Recommended
5
1
mm
125 mm
MAX.
Cylinder size Opening A area Opening B area
9.1 kg (20 lb) >20 000 mm² >20 000 mm²
Getting Started
!
Loading ...
Loading ...
Loading ...