Loading ...
Loading ...
Loading ...
8
G B
• Do not use the pot to store
milk products or baby food as
bacteria could develop.
• Do not lay the pot on its side
if it contains liquid as the liquid
could leak.
• Clean tenacious staining with
special cleaner.
• Use a soft damp cloth to clean
the exterior.
ONLY Melitta
®
LOOK
®
Selection
• To avoid damaging the glass
flask, do not use any hard or
sharp objects to stir or clean
(e.g. cutlery, washing up brushes
etc) and do not use ice cubes
or carbonated drinks with the
insulated pot.
• Do not subject the glass flask to
high temperature variations.
• If the pot is dropped or
subjected to a heavy impact the
glass flask could break. Do not
drink the contents as they could
contain shards of glass.
2. Beforerstuse:
• Ensure that the power supply in your home corres-
ponds to that on the model plate on the base of the
appliance.
• Connect the appliance to a power source. Unused
cable can be stored in the base of the appliance.
• All appliances have been tested during production
for perfect functioning. Therefore there may be
for example water deposits remaining. Rinse the
appliance twice with the maximum amount of water
and without a filter bag or ground coee, in order to
clean it.
• For the best coee enjoyment and convenient use,
the appliance is equipped with various features.
These features are explained below.
3. Set water hardness
Depending on water hardness lime scale may build up
in the appliance. This increases the appliance’s energy
consumption as lime scale on the heating element can
prevent the water heating eectively. To avoid damage
the appliance must be descaled regularly. The descaling
display helps you in this. If the CALC-button is
permanently lit this shows that the appliance needs to
be descaled.
The appliance is pre-set for a high level of water
hardness (level 4). You can find out the level of water
hardness in your area by asking your local water
provider or by using water hardness measuring strips
available in the shops. For softer water the descaling
display can be adjusted to descale less often:
• Hold down the CALC button for longer than 2
seconds. The CALC button starts to flash. In the
factory settings the CALC button flashes briefly four
times with the following pauses …………
• You can set the water hardness at three further
levels. Each time you briefly press the CALC button
the display changes to flashing one, two or three
times, each time followed by a pause
(……, ……, ……).
• The settings and display are shown in the following
table 1.
• Once you have set the desired hardness level, again
hold the CALC button down for longer than two
seconds. The light goes o and your settings are
saved.
Please note:
1. Water hardness cannot be programmed while
brewing.
2. The last water hardness level chosen remains even
after removing the power cable.
4. Making coffee
• Ensure that the appliance is connected to the power
source.
• Open the lid on the water tank.
• Fill the water tank with the desired amount of water
using the therm jug. With the help of the water level
Hardness setting
1
2 3 4
°dH
<7°
dH
7-14° dH
14-21°
dH
>21°
dH
Flash rhythm
CALC button
………… ………… ………… …………
Table 1
Loading ...
Loading ...
Loading ...