Loading ...
Loading ...
Loading ...
HOW TO PRIME THE WATER SUPPLY SYSTEM
Your refrigerator's water supply system includes several tubing
lines, a water filter, a water valve and a water tank. To ensure
that your water dispenser works properly, this system must
be completely filled with water when your refrigerator is
first connected to the household water supply line and
whenever you replace the water filter.
Because of new plumbing connections, the first production of
ice cubes may be discolored or have an odd flavor. Discard ice
made during the first 24 hours.
TURNING YOUR SIDE MOUNTED ICE MAKER ON/OFF
To begin ice production, lower the wire signal arm to the DOWN
or ON position. The ice maker turns off automatically when the
ice container becomes full. To stop the ice maker, raise the wire
signal arm until it clicks and locks in the UP or OFF position
(see Figure 1).
TURNING YOUR REAR MOUNTED ICE MAKER ON/OFF
TO PRIME THE WATER SUPPLY SYSTEM:
• Begin filling the tank by pressing and holding a drinking
glass against the water dispenser paddle.
• Keep the glass in this position until water comes out of
the dispenser. There wilt be noticeable spurts and
sputters as the system pushes air out through the
system and dispenser nozzle. This is normal. This may
take about 11/2minutes.
• Continue dispensing water for about 3 minutes to flush
the system of any air and impurities. Empty glass as
needed.
HOW THE ICE MAKER WORKS
Ice production is controlled by the ice maker's ON/OFF power
switch. To gain access to the ice maker, pull the ice cream shelf
out. Press the switch to the "O" position to turn it Off and press
it to the "1" position to turn it On (see Figure 2). The ice maker
also has a built-in wire signal arm, which automatically stops ice
production when the ice bin is full. DO NOT use this signal arm
to manually stop the ice maker.
J
rj
t
Figure 1 Figure 2
The ice maker and container are located in the top of the
freezer compartment. After the refrigerator is installed properly
and has cooled for several hours, the ice maker can begin
making ice within 24 hours. Air in new plumbing lines may
cause the ice maker to cycle two or three times before making
a full tray of ice. With no usage, it will take approximately two
days to fill the ice container.
Loading ...
Loading ...
Loading ...