Loading ...
Loading ...
Loading ...
9
1. Open the cover, remove the ice basket and pour water into the tank.
Keep the water level below the max water level mark.
2. Press “
ON/OFF
” button on the control panel to begin the ice-making cycle.
3. Ice-making cycle lasts approximately 6 to 13 minutes, which depends on the selection of
ice cube size and the room temperature. The recommended room temperature is 50℉ to
105℉.
4. If the water pump can’t inject water, the ice maker will stop automatically and the “
ADD
WATER
” indicator will be on. Press “
ON/OFF
” button, add water to the max water level
mark ,and press “
ON/OFF
” button to turn on the unit again. Allow at least 3 minutes for the
refrigerant liquid inside the compressor to settle before restarting.
5. The ice maker stops when the ice basket is full and the “
ICE FULL
” indicator will be on.
Warning: Direct sunlight or sunlight reflection may cause inf r ared sensor
malfunction. If the unit doesn’t stop even when ice cubes obstruct the sensor, mo
ve
the unit to where there is no sunlight.
6. Change water in the water reservoir every 24 hours to ensure a reasonable hygienic level.
If the unit isn’t to be used, drain all the water and dry the tank.
PROBLEM POSSIBLE CAUSE SOLUTIO N
“ADD WATER”
indicator is
on.
Lack of Water.
Stop the ice maker, add water, and
press “
ON/OFF
” button again to
restart the unit.
“
ICE FULL
” indicator is on. Ice is full in basket.
Remove ice cubes from the ice
basket.
Continuously press “on/off” button
for 5 seconds and the unit could
make ice for 10 cycles even when
the “Ice” indicator is on.
Ice cubes stick together.
The ice-making cycle is
too long.
Stop the ice maker and restart it
after the ice melts. Select ice cubes
of a smaller size.
The water temperature in
the inner tank is too low.
Change the water.
The recommended water
temperature is 40℉ - 90℉
The ice-making cycle is
normal but no ice cube is
formed.
The room temperature or
the water temperature in
the inner tank is too high.
The room temperature should be
50℉ - 105℉ and the water
temperature should be 40℉ - 90℉
The refrigerant in the
cooling system leaks.
Verify it by a qualified technician.
The pipe in the cooling
system is blocked.
Verify it by a qualified technician.
USING YOUR ICE MAKER
Loading ...
Loading ...
Loading ...