Loading ...
Loading ...
Loading ...
8
Deep cleaning
your machine
Press the Deep clean cycle button
on the front of your machine and
your instructions will be shown on
the LCD screen.
Push down on the shroud release
buttons to remove the shrouds. The
inner door will spring open. Put the
shrouds to one side as you carry out
the Deep clean cycle.
Push down the water tank release
buttons on the sides of your machine.
Slide the water tank out of your
machine and unclip the cap.
Remove the evaporator from your
machine, place it in the water tank
and refit the cap.
1 2
Place the evaporator in the water
tank. Fill the water tank to the
Max level with cold tap water.
Carry the water tank by its handle
to the tap.
Remove the cap and evaporator.
Fill the water tank halfway to the
Max level with cold tap water.
Measure out 150g of citric acid
and place it in the water tank.
Agitate gently until all the citric acid
has dissolved.
MAX level
3
Important: don’t turn off or unplug your
machine as the cleaning instructions will
appear on the LCD screen.
To always get the best performance from your
Dyson purifying humidifying fan, it is important
to carry out regular deep cleaning to remove
any limescale.
Before and after long periods where
humidification is not used, it is recommended
that additional Deep clean cycles are run.
In hard water areas you may need to run the
Deep clean cycle more frequently. Your machine
will alert you when it needs you to carry out a
Deep clean cycle.
If you are connected to the Dyson Link app,
you will receive a notification message.
If you are not using the Dyson Link app, the
LCD screen on your machine will alert you
and the Deep clean cycle button will light up.
To cancel the Deep clean cycle at any point,
press and hold the Deep clean cycle button
for five seconds.
Loading ...
Loading ...
Loading ...