Loading ...
Loading ...
Loading ...
If Accessories Needed :
Installation For 29" Existing Cutout Width Opening
1. You must replace the actual side trims by new and
smaller side trims. These new side panels can be
ordered through a Sears Service Center.
2. Follow instructions supplied with your new side trims
to replace the actual side trims with the new ones.
3. Check if the countertop is prepared for 29" cutout
wide opening at page 7.
4. Install range as in the "Installation Without Side
Panels" section above.
Installation With Backguard
A backguard kit can be ordered through a Sears Service
Center.The cutout depth (21 3/4" (55.2 cm) Min.,
22 1/8" (56.2cm) Max.) needs to be increased to24"
(61 cm) when installing a backguard
Installation With End Panel
An end panel kit can be ordered through a Sears
Service Center.
Installation With Side Panel
A side panels kit can be ordered through a Sears
Service Center.
Install cabinet doors 31 " (78.7 cm) rain. apart so as not
to interfere with range door opening.
Leveling the Range
Models Equipped with Leveling Device
_ Level the range after installation in the cutout
opening.
I. Open the range drawer. The leveling screws
control the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop surface is sitting level
on the countertop (Figure 9).
a.To adjust the front legs, use a wrench on
the leg base and turn clockwise to lower or
counterclockwise to raise.
b.To adjust the rear legs, use a ratchet or a
nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to
raise.
3. Check if the range is level by installing an oven
rack in the center of the oven and placing a
level on the rack (Figure 10).
4. Take 2 readings with the level placed
diagonally in one direction and then the other.
Level the range, if necessary, by adjusting the
leveling legs.
5. If the range cannot be level, contact a
carpenter to correct sagging or sloping floor.
Models Equipped with Leveling Legs
Level the and set before
cooktop heightrange
installation in the cut-out opening.
I. Install an oven rack in the center of the oven.
2. Place a level on the rack (see Figure 10). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 16).
3. Taking care to not damage the countertop, slide
range into cutout opening and double check for
levelness.
to Ad ust Rear Leveling
Device H ig _t
Leveling _j
Screw--
Font
Leveling
Leg
LOWER
RAISE
Figure 9
Figure 10
Loading ...
Loading ...
Loading ...