Loading ...
Loading ...
Loading ...
Setting Surface Controls
Models with Ceramic Glass Cooktop and Electronic Surface Element
Control (ESEC) (some models)
The Electronic Surface Element Control (ESEC) feature includesdigital
display windows. The ESEC feature provides a numeric digital setting
for the radiant surface element positions on the cooktop. These settings
work the same way as normal knob setting indicators work except the
settings are displayed in digital windows (Figures. t thru 4).
The available ESEC Display Settings
The ESEC control provides various heat levels from Hi (Figure 2) to Lo
(Figure 3) and OFF (Figure 1). The settings from Hi to 3.0 decrease in
increments of .5. The settings from 3.0 to Lo (Simmer settings)
decrease in increments of .2 for more precise settings of lower heat
levels.
Use the chart (on page 1O)to determine the correct setting for the kind
of food you are preparing. The Simmer settings are used to simmer and
keep larger quantities of foods warm such as stews and soups. The
lower Simmer settings are idealfor delicate foods and melting chocolate
orbutter.
Element configuration, appearance and graphics of
cooktops may be differents -
Dual Surface Radiant Element shown below
°me
Small Large
Petit Grand
OFF
hi hi
Figu re 1
/
Note: The size and type of cookware used will influence the setting o _ @
Srt_ii _ Large
needed for best cooking results. Petit Grand
OFF
Radiant surface elements may appear to have cooled hi hi
after they have been turned off. The HE message will come on and will hi" _\
stay in the display until the glass cooktop has cooled down to a
moderate level. The glass surface may still be hot and burns may
occur if the glass surface is touched before it has cooled sufficiently.
_Do not place plastic items such as salt and pepper _i_i_
shakers, spoon holders or plastic wrappings on top of the range when -- s,_,,_
it is in use. These items could melt or ignite. Potholders, towels or Figure3
wooden spoons could catch fire if placed too close to the surface
elements.
°me
Small Large
Petit Grand
OFF
hi hi
Figure2
o @
Small Large
Petit Grand
OFF
hi hi
Figure4
Hot Element indicator Message (HE)
After using any of the radiant element positions the cooktop will become very hot. Even after turning the
control knob to OFF, the cooktop will remain hot for some time. The ESEC control monitors the tempera-
ture of the cooktop and displays the message "HE" (hot element) warning when the cooktop is still too hot
to touch (Figure 5). If the HE message appears in the window, the control can be turned on again for use.
m
Figure5
ESEC Error indicator Message (Er)
An error message will be displayed (flashing "Er") at power up (or after a power failure) ifANY of the surface
control knobs were left in the ON positions (See Figure 6). If a power failure should occur, be sure to set all
of the surface control knobs to the OFF position. This will reset the surface controls.
Once the surface controls have been set to the OFF positions, the surface controls should return to normal
operation. Ifthe surface controls do not function and the"Er" message remains inany display after following
these procedures, contact an authorized servicer for assistance.
ESEC Lockout Feature ( - - )
The ESEC feature will not operate during a Self-Clean cycle. Whenever the ESEC Lockout feature is active,
" - -" will appear inany display window (See Figure 7).
m
Figure6
m
Figure7
Loading ...
Loading ...
Loading ...