Loading ...
Loading ...
Loading ...
05 06
WARNING! If the battery pack or charger is damaged, replace the battery pack or the
charger.
WARNING! Stop the machine and wait until the motor stops before you install or remove
the battery pack
WARNING! Read and understand the instructions in the battery and charger manual.
3. REMOVE THE BATTERY PACK
1）. Push and hold the battery release button.
2）. Remove the battery pack from the machine.
4. START THE MACHINE
Press the switch to trigger 4.
5. STOP THE MACHINE
Release the trigger(component 4) to stop the machine.
4
4
7. MAINTENANCE
CAUTION! Do not let brake fluids, gasoline, petroleum-based materials touch the plastic
parts. Chemicals can cause damage to the plastic, and make the plastic unserviceable.
CAUTION! Do not use strong solvents or detergents on the plastic housing or compo-
nents.
WARNING! Remove the battery pack from the machine before maintenance.
6. OPERATION TIPS
Release the trigger(component 4) to stop the machine.
Blow around the outer edge of the unwanted materials to prevent the unwanted materials from
scattering. Use rakes and brooms to clear the unwanted material before you blow.
Make the surfaces wet before you clear the unwanted material in dusty conditions.
Look out for children, pets, open windows, and cleaned cars during operation.
Clean the machine.
Discard the unwanted material when you complete work.
CAUTION! The machine must be dry Humidity can cause risks of electrical shocks.
8. CLEAN THE MACHINE
Clear the unwanted material out of the air vent with a vacuum cleaner.
Do not spray the air vent or put the air vent in solvents.
Clean the housing and the plastic components with a moist and soft cloth
9. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop Relieve the load on the machine immediately and
allow cooling for approx 30 seconds.
10. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended the power tool cannot be subject to overload. When the load is too high
or the allowable battery temperature of 75° C is exceeded the electronic control switches off the
power tool until the temperature is in the optimum temperature range again.
11. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the"Discharging Protection System.
When the battery is empty, the machine is switched off by means of a protective circuit: The
inserted tool no longer start.
Loading ...
Loading ...
Loading ...