Loading ...
Loading ...
Loading ...
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)
“Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement."
Neither Segway Inc. nor Ninebot is responsible for any changes or modifications not expressly approved by Segway Inc.
or Ninebot. Such modifications could void the user's authority to operate the equipment.
FCC ID: 2ALS8-NB9676
IC: 22636-NB9676
12 Certifications
16 17
11 Specifications
Dimensions
Weight
Machine
Parameters
Battery
Motor
Charger
Features
Brake Light
Unfold: Length x Width x Height
Fold: Length x Width x Height
Payload
Rider
Recommended Age
Required Height
Max. Speed
Typical Range
[1]
Max. Slope
Operating Temperature
Storage Temperature
IP Rating
Duration of Charging
Traversable Terrain
Max. Charging Voltage
Charging Temperature
32–104°F (0–40°C)
Nominal Capacity
Battery Management System
Input Voltage
Output Voltage
Output Current
Nominal Voltage
Nominal Power
Output Power
~ 45.9 × 18.6 × 47.4 in (1167 × 472 × 1203 mm)
~ 45.9 × 18.6 × 21.0 in (1167 × 472 × 534 mm)
66.1–220.5 lbs (30.0–100.0 kg)
Approx. 40.4 miles (65 km)
Approx. 15%
36 VDC
14–104°F (-10–40°C)
-4–122°F (-20–50°C)
42 VDC
551 Wh
350 W
Over-heating, short circuit, over-current and over-charge
protection
Number Of Batteries
1
100–240V ～ 50/60Hz
42 VDC
2.9 A
121 W
14+ years
3’11”–6’6” (120–200 cm)
IPX5
~ 6 h
asphalt/flat pavement; obstacles < 0.4 in (1 cm);
gaps < 1.2 in (3 cm)
Approx. 15.5 mph (25 km/h)
LED rear light
Riding Modes Energy Saving mode, Standard mode and Sport mode
Net
Approx. 41.2 lbs (18.7 kg)
G30Item
[1]
Typical Range: tested while riding under full power, 165.3 lbs (75.0 kg) load, 77°F (25°C), 9.3 mph (15 km/h) on average on pavement.
Loading ...
Loading ...
Loading ...