Loading ...
Loading ...
Loading ...
7
the battery release button (10) as shown in
figure c and pull battery pack out of tool.
B
c
10
aSSeMBly InSTrucTIonS
warnInG: Make certain the battery
is removed before assembly or
disassembly of any parts.
aSSeMBly ToolS reQuIred (noT
SuPPlIed):
- Phillips Screwdriver
aTTacHInG Guard and BaIl Handle
To TrIMMer
warnInG: only use with handle and
guard properly assembled to hedge
trimmer. The use of the hedge trimmer
without the proper guard or handle provided
may result in serious personal injury.
The trimmer is shipped with the guard and
bail handle attached to the trimmer with a
plastic zip tie.
To assemble to trimmer:
• Cut the plastic zip tie.
• Remove the six screws that are partially
run into the trimmer housing (figure d).
d
• Slide the guard (5) onto the front of the
trimmer housing as shown in figure e.
• Insert two of the six screws into the
openings on the sides of the guard and
tighten securely.
e
• Slide the bail handle (6) onto the front of
the trimmer housing behind the guard
as
shown in figure f
.
• Insert the remaining four screws into the
openings on the sides of the bail handle
and tighten securely.
f
oPeraTIon
SwITcH
•
To turn the unit on, push the lock off
button (2) down and squeeze the trigger
(1), as shown in figure G. Once the unit
is running, you may release the lock-off
button.
In order to keep the unit running
you must continue to squeeze the trigger.
• To turn the unit off, release the trigger.
warnInG: NEVER ATTEMPT TO
LOCk A SwITCH IN THE ON POSITION.
G
Loading ...
Loading ...
Loading ...