Loading ...
Loading ...
Loading ...
19
B O S C H
Trouble shooting
Problem Probable cause Solution
The iron does not
heat up.
1. Temperature control (15) set
to minimum.
2. The “SensorSteam” system
has been activated. The iron is
set to stand-by.
1. Turn to a higher position.
2. Grip the handle (1) of the iron
to re-start it.
“SensorSteam”
indicator lamp (3)
ashes.
1. The “SensorSteam” system
has been activated. The iron is
set to stand-by.
1. Grip the handle (1) of the iron
to re-start it.
The lights inside
the temperature
control (15) ash.
1. The soleplate is heating up or
cooling down to the selected
temperature.
1. This is normal and lights will
stop ashing when the
selected temperature is
reached.
The clothes tend to
stick.
1. The temperature is too high. 1. Turn the temperature control
(15) down and wait until the
iron has cooled down.
Water drips out of
the soleplate
together with
steam.
1. Temperature control (15)
setting is too low.
2. You have pressed the shot of
steam button (7) repeatedly
without waiting for 5 seconds
between each press.
1. Turn the temperature control
(15) to a higher setting and
wait until the “TempOK” lights
inside the temperature control
stop ashing and remain lit
continuously.
2. Wait 5 seconds between each
press of the shot of steam
button.
Steam does not
come out in
horizontal position.
1. Steam control is set to “
”
position.
2. The temperature is too low.
Anti-drip system is activated.
1. Set the steam control to “eco”
or “max” position.
2. Set to a higher temperature if
compatible with the fabric.
Excessive dripping
or steaming.
1. No proper closing of
“Calc’nClean” system.
1. Actuate a few times the
“Calc'nClean” button (16).
The pump does not
work.
1. The iron is not in a horizontal
position.
1. Use the iron in a horizontal
position.
Smoke comes out
when connecting
the iron for the rst
time.
1. This may be caused by the
lubrication of some of the
internal parts.
1. This is normal and will stop
after a few minutes.
Deposits come out
through the holes
in the soleplate.
1. Traces of lime scale are
coming out of the steam
chamber.
1. Carry out a cleaning cycle
(see “Calc’nClean” section).
The appliance
makes a pumping
sound.
1. Water is being pumped into
the steam chamber.
1. This is normal.
If none of the above solves the problem, get in touch with an authorised technical service.
Loading ...