Loading ...
Loading ...
Loading ...
6
ENGLISH
REAR
PANEL
JACK/FEMALE XLR INPUTS (BAL/UNBAL). The system accept jack or XLR
input connectors. These balanced inputs can be used to connect balanced
or unbalanced microphones or audio sources at line level. The balanced
connector is connected in parallel and can be used to send the audio signal to
other amplified speakers, recorders or supplementary amplifiers.
LIMITER LED. The amplifier has a built in limiter circuit to prevent clipping
of the amplifiers or overdriving the transducers. When the soft clipping circuit
is active the LED blinks RED. It is okay if the limit LED blinks occasionally. If the
LED blinks frequently or lights continuously, turn down the signal level.
SIGNAL LED. The signal indicator lights green if there is signal present on
the main input.
POWER STATUS LED. This green led is ON when the speaker is connected
to the main power supply and the ON/OFF is in ON position.
MALE XLR SIGNAL OUTPUT. The output XLR connector provides a loop
trough for speakers daisy chaining.
VOLUME CONTROL. Adjust the amplifier volume. This control does not
affect the “Link” - “Input - Link” output level.
FLAT/BOOST SWITCH. Set the flat or boost equalization. “Boost” equalization
is a loudness recommended for music applications, when the system plays on a
floor stand. For monitoring applications, when the system is on the floor, “Flat”
equalisation is recommended.
INPUT SENSITIVITY SWITCH. Position the switch in LINE to use a line level
source (0 dB) or MIC to use a microphone source.
IEC AC SOCKET. The IEC AC socket connect the power cord to the socket.
FUSE CARRIER. Mains fuse housing.
POWER MAIN SWITCH. The power switch turns the AC power ON and OFF.
WARNING: the VDE Power Connector is used to disconnect the system from
the power supply network. It shall be easily accessible after the installation
and during the use of the system
11
1
1
6
2
3
4
5
7
8
9
10
1
2
3
4
5
6
7
8
9
10
11
The XLR connectors
use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
CONNECTIONS
HOT GND
BAL. XLR
COLD
Loading ...
Loading ...
Loading ...