Loading ...
Loading ...
Loading ...
8
INSTALLATION INSTRUCTIONS
INSTALLATION LOCATION
• This refrigerator is designed for indoor, household use only.
• Keep away from heat and avoid direct sunlight or places near
a heat source, such as an oven or a radiator.
• Do not place the refrigerator in moist or watery places to
prevent rust or reduction of insulating effect to affect the
electrical insulation properties of the refrigerator.
• The refrigerator is placed in a dry and well-ventilated indoor
place.
• The ground shall be at, and sturdy (rotate the adjustable leg
left or right to adjust for leveling if unstable.)
• The temperature of the location ranges from a minimum of
55°F to a maximum of 110°F. However, for better energy
usage and superior cooling, the temperature is preferred to
be between 60°F and 90°F.
• For proper air circulation and electric connections, allow a
2" clearance on each side and behind the refrigerator. Allow
a 2" clearance at top of the refrigerator.
• Spare enough space for convenient opening of the doors and
drawers, especially when the refrigerator is installed next to
a xed wall to allow the door to swing open.
ELECTRICAL CONNECTION
Before plugging in, ensure that the voltage and frequency shown
on the rating plate correspond to your domestic power supply.
The appliance must be grounded. The power supply cable plug
is provided with a contact for this purpose. If the domestic
power supply socket is not grounded, connect the appliance
to a separate ground in compliance with current regulations,
consulting a qualied electrician.
The manufacturer declines all responsibility if the above safety
precautions are not observed.
This appliance complies with the E.E.C. Directives.
DOOR REVERSIBILITY
Before reversing the door, please be prepared below tools and
material: phillips head screwdriver, socket wrench, wrench and
components included in the poly bag:
Left Door Hinge
Cover x 1
Left Aid-Closer on
Upper Door x 1
Left Aid-Closer on
Lower Door x 1
TOOLS TO PREPARE
Phillips Head
Screwdriver
Socket Wrench Wrench
1. Unscrew top hinge cover and disconnect connector of door
switch.
2. Unscrew top hinge with screwdriver or ¼” socket wrench
and remove the upper door.
3. Remove the pin with a wrench or 3/8” socket wrench and
ip the hinge bracket. Then ret the pin to the hinge bracket.
Unscrew
Screw
Loading ...
Loading ...
Loading ...