Loading ...
Figure 1.5
Figure 1.6
• Do not add water directly into the
base chamber. [
Figure 1.5
]
• Do not add water through the mist
tube. [
Figure 1.6
]
• Do not add essential oils or
supplemental water treatment liquids
into the humidifier.
• Do not use third-party water filters.
CAUTION
USING YOUR HUMIDIFIER
1. Rotate the Control Knob clockwise to turn
the humidifier on. Adjust the knob to your
desired mist level.
2. Rotate the nozzle to adjust the direction of
the mist. [
Figure 2.1
]
3. When your room has reached your
preferred humidity level, turn the
humidifier to a lower setting, or turn it o.
4. Rotate the Control Knob counterclockwise
to turn the humidifier o.
Figure 2.1
Note:
If there is no water in the tank or the tank is
removed, the humidifier will stop misting and the
Refill Indicator Light will turn on. Refill the tank and
place it on the base.
Figure 2.2
Important Tips
Your humidifier must have the correct level of
water in the base chamber to work properly. If
there is too much water in the base chamber,
the humidifier cannot create mist.
• Only add water to the water tank.
• Avoid moving or shaking the humidifier.
• Before moving the humidifier, turn it o,
unplug it, and remove the water tank.
• If your humidifier doesn’t produce mist
correctly, check the max water line to
see if there is too much water in the
base chamber. Pour out extra water.
[
Figure 2.2
]
Note:
The max water line is
only
for this
purpose.
Figure 3.1
CARE & MAINTENANCE
• All maintenance should be done on a
water-resistant surface.
• Change the water daily to avoid
bacteria growth.
• Use a tissue or cloth to clean the nozzle
regularly.
• If not using the humidifier for 3 days or
longer, do not leave water inside.
Note:
When pouring out water, hold down the
float to ensure that it does not fall out of the
base chamber.
Note:
•
Never
immerse the base in water or liquid.
Do not
place any part of the humidifier in a
dishwasher.
•
Do not
use detergents to clean the humidifier.
Cleaning
You should clean your humidifier every
3 days, and when you’re ready to store it.
1. Unplug the humidifier. Remove and
rinse the water tank cover and dust
cover. [
Figure 3.1
]
2. Remove the water tank and pour out
any water from the tank and base
chamber.
Figure 3.2
3. Remove the water filter from the tank by
rotating it counterclockwise.
[
Figure 3.2
]
4. Rinse the tank, water filter, and base
chamber with room temperature water.
Descaling Your Humidifier
Figure 3.3
Figure 3.4
Figure 3.5
Figure 3.6
Figure 3.7
Reassembling
1. Flip the water tank over and place the
noise silencer back into the tank.
2. Place the water filter back into the tank
and rotate it clockwise to secure it in
place.
3. Place the float back into the base
chamber:
a. Make sure the correct side of the
float is facing up.
b. Insert the smaller prong into the
closed side of the float brackets.
[
Figure 3.8
]
c. Place the larger prong into the
open (U-shaped) side of the float
brackets.
4. Place the tank on the base and place
the cover on top.
Figure 3.8
Storing
Follow the cleaning instructions (see page 7)
and allow all parts to dry completely before
storing. Store in a cool, dry location.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT PART 18
This device complies with part 18 of the FCC Rules.
This equipment generates and uses ISM frequency energy and if not installed and used properly, that is in strict
accordance with the manufacturer’s instructions, may cause interference to radio and television reception. It has been
type tested and found to comply with limits for an ISM Equipment pursuant to part 18 of FCC Rules, which are designed
to provide reasonable protection against such interference in a residential installation. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by tuning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following:
• Reorient the receiving antenna of radio or television.
• Relocate the equipment with respect to the receiver.
• Move the equipment away from the receiver.
• Plug the equipment into a dierent outlet so that the equipment and receiver are on dierent branch circuits.
Conduct only the user maintenance found in this manual. Other maintenance and servicing can cause harmful interference
and can void the required FCC compliance. The manufacturer is not responsible for any radio or TV interference cause by
unauthorized modification to the equipment. It is the responsibility of the user to correct such interference.
Terms & Policy
Arovast Corporation (“Arovast”) warrants this
product to the original purchaser to be free from
defects in material and workmanship, under
normal use and conditions, for a period of 2 years
from the date of original purchase.
Arovast agrees, at our option during the
warranty period, to repair any defect in material
or workmanship or furnish an equal product in
exchange without charge, subject to verification
of the defect or malfunction and proof of the date
of purchase.
There is no other express warranty. This warranty
does not apply:
• If the product has been modified from its
original condition;
• If the product has not been used in
accordance with directions and instructions
in the user manual;
• To damages or defects caused by accident,
abuse, misuse or improper or inadequate
maintenance;
• To damages or defects caused by service
or repair of the product performed by an
unauthorized service provider or by anyone
other than Arovast;
• To damages or defects occurring during
commercial use, rental use, or any use for
which the product is not intended;
• To damages or defects exceeding the cost
of the product.
Arovast will not be liable for indirect, incidental,
or consequential damages in connection with the
use of the product covered by this warranty.
This warranty extends only to the original
consumer purchaser of the product and is
not transferable to any subsequent owner
of the product regardless of whether the
product is transferred during the specified
term of the warranty.
This warranty does not extend to products
purchased from unauthorized sellers. Arovast’s
warranty extends only to products purchased
from authorized sellers that are subject to
Arovast’s quality controls and have agreed to
follow its quality controls.
All implied warranties are limited to the period of
this limited warranty.
This warranty gives you specific legal rights
and you may also have other rights which
vary from state to state. Some states do not
allow the exclusion or limitation of incidental
or consequential damages, so the above
limitation or exclusion may not apply to you.
If you discover that your product is
defective within the specified warranty
period, please contact Customer Support
via [email protected]. DO NOT dispose
of your product before contacting us. Once
our Customer Support Team has approved
your request, please return the product
with a copy of the invoice and order ID.
Every Levoit product automatically includes a
2-year warranty. To make the customer support
process quick and easy, register your product
online at www.levoit.com/warranty.
This warranty is made by:
Arovast Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
Product
Classic 300 Lite Ultrasonic
Cool Mist Humidifier
Model LUH-A603-WUS
For your own reference, we strongly recommend
that you record your order ID and date of purchase.
Date of Purchase
Order ID
WARRANTY INFORMATION
CUSTOMER SUPPORT
If you have any questions or concerns
about your new product, please contact our
helpful Customer Support Team.
Arovast Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
Email: [email protected]
Toll-Free: 888 7268520
MonFri, 9:00 am5:00 pm PST/PDT
Support Hours
*Please have your order invoice and order ID
ready before contacting Customer Support.
A1-01.00_D_22A06_us
76 8 9 10
1. Remove the water filter from the tank by
rotating it counterclockwise.
2. Fill the tank with 3 US cups / 710 mL of
distilled white vinegar.
3. Replace the tank cover and swish the
vinegar around the tank. [
Figure 3.3
]
4. Place the tank on the base and soak for
15–20 minutes. Vinegar will drain into
the base chamber and loosen scale
(mineral buildup). [
Figure 3.4
]
5. Pour out any vinegar and flip the tank
over. Remove the noise silencer by
pressing the release tab and gently
pulling it o. [
Figure 3.5
]
6. Remove the float from the base
chamber by pulling up the larger side
of the float [
Figure 3.6
] and pulling the
shaft out from the float brackets. One
side of the brackets is open (U-shaped)
to allow removal. [
Figure 3.7
]
7. Place the float, water filter, and noise
silencer in a container. Fill with enough
vinegar to cover them. Soak for 15–20
minutes.
8. Use the cleaning brush and a soft cloth
to remove scale from all parts.
9. Rinse all parts until any vinegar smell is
completely gone.
10. Completely dry all parts with a cloth
before reassembling.
Problem Possible Solution
Little or no mist
comes out.
Turn the mist level to a higher setting.
There may be too much water in the base chamber. Empty the base chamber.
Refill the water tank (not the base chamber) and place the water tank properly
onto the base.
Make sure the air inlet on the bottom of the base is not blocked. The humidifier
should not be set on carpet or other surfaces that may block the air inlet.
Make sure the nozzle is not blocked or clogged.
Humidifier produces
an unusual smell.
If the humidifier is new, unplug and rinse all parts, then place in a cool, dry place
for 12 hours.
Clean the water tank and base chamber (see Care & Maintenance, page 6).
Condensation forms
around humidifier or
windows.
Humidity may be too high. Turn down the mist level, turn o the humidifier, or
open a door or window in the room.
Mold grows inside
the humidifier.
Clean the water tank and base chamber regularly (see Care & Maintenance,
page 6).
Refill Indicator Light
turns on.
Fill the water tank.
Place the water tank properly on the base.
Clean the water filter (see page 7) or replace it with a new one. To request a
new water filter, contact Customer Support (see page 10).
TROUBLESHOOTING
FCC SDOC SUPPLIER’S DECLARATION OF CONFORMITY
Arovast Corporation hereby declares that this equipment is in compliance with the FCC Part 18 Subpart B. The declaration of
conformity may be consulted in the support section of our Web site, accessible from www.levoit.com