Loading ...
Loading ...
Loading ...
11
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet (Fig. 1) .
2. Remove power head and place in upside down position.
3. Install the cartridge lter over the lter cage with the at end of the lter towards the power head.
Carefully push lter in until it stops against the power head (Fig. 2 & 3).
4. Place lter retainer on top of cartridge lter over the raised lip and tighten down by turning
retainer clockwise; do not over-tighten (Fig. 4 & 5).
Removing and Cleaning Cartridge Filter
1. Unlock and remove the lter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge lter up for removal (Fig. 6).
3. Clean the cartridge lter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new lter is recommended.
4. Install cleaned or new lter as above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet lters should be removed and allowed to air dry for 24 hours before installing onto the lter
cage.
IMPORTANT! Clean or change the cartridge lter regularly for best performance.
ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the
cartridge lter, the motor will burn out and the warranty will be voided. Always keep spare lters on
hand.
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
INSTALLING & CLEANING CARTRIDGE FILTER
2 3 4 5 61
Loading ...
Loading ...
Loading ...