Loading ...
Loading ...
2
CAPABILITIES
ENGLISH
Model 99Ci
KEY
A. SafeSense
®
Technology
B. Paper entry
C. See safety instructions
D. CD/Card safety flap
E. Pullout bin
F. Casters
G. Disconnect power switch
1. OFF
2. ON
H. Control Panel and LEDs
1. Overheat (red)
2. Bin open (red)
3. Bin full (red)
4. Remove Paper (red)
5. SafeSense
®
indicator (yellow)
6. Reverse
7. ON/OFF (blue)
8. Forward
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always
set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse ( ) to back out
object.
• DO NOT use aerosol products, petroleum based or aerosol lubricants on or near
shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON SHREDDER.
Vapors from propellants and petroleum based lubricants may combust causing
serious injury
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• This shredder has a Disconnect Power Switch (G) that must be in the ON (I)
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
A.
B.
D.
C.
G.
F.
E.
H.
Will shred: Paper, plastic credit cards, CD/DVDs, staples and small paper clips
Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard,
large paper clips, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut ...............................................................................5/32” x 1-1/2” (4 x 38mm)
Maximum:
Sheets per pass ........................................................................................................... 18*
CDs/Cards per pass ....................................................................................................... 1*
Paper entry width .............................................................................................9”/230mm
*8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 5Amps; heavier paper, humidity or other than rated
voltage may reduce capacity. Recommended daily usage rates: 1500 sheets per day, 50 credit cards;
10 CDs. 18 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
BASIC SET UP
CASTER INSTALLATION
1
1
8
2 3 4 5
BASIC SHREDDING OPERATION
Continuous operation:
30-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
30-minutes will trigger
40-minute cool down period.
3
ADVANCED PRODUCT FEATURES
Press ( ) ON to
activate (blue)
PAPER OR CD/CARD
Feed paper straight into
paper entry and release
Plug in and put
disconnect power
switch in ON (I) position
When finished
shredding set to
OFF ( )
SilentShred™
Technology
SilentShred™ noise quality
shreds without noisy disruptions.
Patented SafeSense
®
Technology
Stops shredding immediately when hands
touch the paper opening.
Jam Proof System
Eliminates jams and
powers through tough jobs.
1
8
1
8
1
8
4
3
5
21
21
6
or
To shred CDs or credit
cards rotate safety flap
into place
Hold card/CD at edge.
Feed into center of
entry and release
*100% Jam Proof when used in accordance with user manual
Advanced Jam Prevention- Electronically
measures paper thickness to prevent paper jams:
Remove several sheets until
indicator is below red.
Continue 100% Jam
Proof Shredding
If a misfeed
occurs:
If illuminates after paper has been
reversed, press reverse and remove paper.
Otherwise, regular shredding will resume.
1 2 3
Up to RED: Too many
sheets have been inserted.
Up to GREEN: More sheets
can be added.
Up to YELLOW: Productivity
is optimized.
All indicators light up and
shredder pauses for 3-6 seconds
Wait for flashing to stop after automatic correction
is complete. Regular shredding will resume.
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
or
SET-UP AND TESTING
Turn the shredder ON
( ) to activate SafeSense
®
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active and
working properly
If hand is held on SafeSense
®
area more than 3 seconds
shredder will shut off
WHEN IN SLEEP MODE
In sleep mode
To get out of sleep mode
touch control panel
insert paper
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
ENERGY SAVINGS SYSTEM
• Saves energy in four ways: energy-efficient electronics, jam prevention,
standby mode and sleep mode.
• Sleep Mode shuts down shredder after 2 minutes of inactivity.
Optimal energy efficiency 100% of
the time – in use and out of use.
1
8
1
8
1
8
3
1
8
1
8
1
3
2 4
2
1
2
2
Eliminates paper jams and powers through tough jobs.
JAM PROOF SYSTEM OPERATION*
Loading ...
Loading ...
Loading ...