Loading ...
Loading ...
Loading ...
8
- Set the steam control to the steam position w (fig. 6).
- Press and hold the Extra Steam button (J)
0 (max. 5 seconds) (fig. 7).
Then release the button.
Wait at least 1 minute before applying Extra Steam again to prevent water
from dripping out of the soleplate.
Spraying T (types HI 215/216/225/226) (see table)
- To remove stubborn creases from fabrics at any temperature, push the spray button
T (C) a couple of times to damp the laundry (fig. 8).
Make sure there is enough water in the water reservoir.
Self-cleaning 1
The iron has a self-clean function to remove scale and impurities.
Use the self-clean function once every two weeks. If the water used is very hard,
you should use the self-clean function more often.
- Set the Steam control (B) to position O (fig. 2).
- Set the temperature control dial (A) to MAX.
- Fill the water reservoir (G) to maximum (MAX) level.
- Plug in the iron to the mains, allow the iron to heat up.
- When the amber pilot light (E) goes off, unplug the iron.
- Hold the appliance horizontally over a sink (fig. 9).
- Set the steam control to position 1 (self clean) (fig. 10).
The steam control will then spring up slightly.
- Pull the steam control up slightly (fig. 10).
- Boiling water and steam will now come out of the holes in the soleplate.
Impurities and scale (if any) are washed away with it.
Move the iron forwards and backwards while this happens (fig. 11).
- Repeat self-clean if a lot of impurities are flushed out.
- You can pull the steam control further upwards to remove the steam control
needle (fig. 12). It is then possible to remove any scale from the needle.
For this purpose you may use vinegar.
Avoid bending or damaging the steam control needle!
- Replace the steam control needle. Insert the point of the needle exactly in the
centre of the aperture and fit the small notch at the side into the spacing (fig. 13).
- Press the steam control (fig. 14).
- Set the steam control to position O (fig. 2).
Do not put vinegar, starch, chemically descaled water or descaling agents in
the water reservoir.
Loading ...
Loading ...
Loading ...