Loading ...
Loading ...
Loading ...
9
EN
2. DRAIN HOSE KIT
Included in some models only. If not
supplied, it can be purchased
separately.
The kit consists of: 1 hose and 1 bung.
In order to avoid to empty the water
container after each drying cycle, the water
can be discharged directly to a waste water
drain pipe. Water Bye-Laws prohibit
connection to a surface water drain. The
waste water drain pipe should be located
adjacent to the tumble dryer.
1. The water drainage system is located at
the back of the machine on the lower
right side (figure 2).
2. Remove the cover (figure 3).
3. Disconnect the hose (A) from the fitting
(B) by pulling it upwards. Close the
extracted tube with the cap (C) supplied
with the kit (figure 4).
4. Connect the hose into the fitting (B)
making sure it is inserted securely
(figures 5-6).
Once the machine is in place, check to
ensure that the new hose does not
kink when pushing the tumble dryer
into position.
Fitting the drain hose
The hose must be connected to a drain
system with a maximum height of 85
cm compared to the base of the dryer
(figure 1).
WARNING
Switch off and remove the tumble
dryer plug from the electricity supply
before carrying out any work.
Loading ...
Loading ...
Loading ...