Loading ...
Loading ...
First find the battery position of the car, determine the positive and negative
poles of the battery, clamp the red clamp on the positive pole of the battery
(corresponding to the battery +), clamp the black clamp on the negative
pole of the battery (corresponding to the battery-), and then start the car.
(See Fig. 3)
2:
Pull out the test plug and store it for use by the testing machine (the test
plug is an important part for checking and analyzing machine faults). Link
the hose quick connector to the inflation container, turn the switch to start
the machine, and tighten the bleeder valve to start inflation after ensuring
everything is normal. During the inflation process, the operator should not
be too close to the inflation container, please keep a certain safe distance.
Closely observe the indicated pressure of the pressure gauge. The
maximum design pressure of this machine is 30Mpa. When the pressure is
expressed to the required pressure value, please close the switch in time,
then open the vent valve, and disassemble the quick connector after
draining all the air and water. (See Fig. 4)
3:
If you need to use the machine under the voltage of 110V-220V, please use
our optional conversion power supply device. There is a built-in toggle
switch (110V and 220V indicators) on the side of the power supply device.
The switch should be toggle according to the voltage of the place where it
is used (if the place is 110V, turn the switch to 110V, if the place is 220V,
turn the switch to 220V). If the direction is wrong, the power supply
converter will be damaged. Make sure the power supply is correct before
using the machine normally. The operation is carried out according to the
previous usage process. (See Fig. 5)
see Fig. 3
see Fig. 4
4:
Instructions For Use Instructions For Use
-3- -4-
11.5-14V DC power supply is required for normal operation of this
machine. Connect the power line to the machine, make sure the machine
switch is shut down, and release the vent valve. (See Fig. 2)
II. Instructions for Use:
see Fig. 2
1:
see Fig. 5
Loading ...