Loading ...
Loading ...
Loading ...
9. Use wrenchesto removehex lock nut (D).
Removetwospacers(E),andhexbolt(F)from
top of the housing assembly.For easy
assembly,do not removethe secondspacer
fromthehexbolt.SeeFigure5.
10.Placethe dischargechutein positionon the
dischargeopening.Insert hex bolt (F) and
spacer(E) throughhingeon dischargechute
andhousing(spacerfitsinsideofhinge).
11.Placesecondspacer(E)overhexbolt(F)inside
theotherhalfofthehinge.Securewithhexlock
nut(D).Tightensecurely.
12.Securebothsidesof dischargechuteto flail
housingusingwingknobs(C). Tightenwing
knobs.
ATTACHING THE CHIPPER CHUTE
(Model 463 or 465 chipper shredders)
Weld Stud (A)
,
7.
4. Replace the three cupped washers (cupped side
against the chipper chute) and hex nuts that you
removed in step 1. Do not tighten the nuts at this
time. Make sure to place the cupped side of the
washer against the chipper chute.
5. Your unit is shipped with one end of the brace
already secured to the lower frame. Loosen the
bolts securing the brace to the frame.
Align the holes on the chute with the holes on
the brace.
,
9.
Attach brace to chipper chute with the hardware
removed earlier from the brace. Tighten
securely. See Figure 6.
Tighten the bolts securing the brace to the
frame.
Tighten the three nuts on the weld studs holding
the chipper chute to the flail housing.
ATTACHING THE BAG
All Models
1. To attach the bag, place the opening of the bag
over the chute deflector so it completely covers
the chute deflector. See Figure 7.
2. Depress the plunger on the drawstring, and pull
on the drawstring until the bag is tight around the
chute opening. Release plunger to lock it into
position. See Figure 7.
Hex
Brace
Weld Stud (A)
Figure 6
1. Remove the three cupped washers and hex nuts
from the weld studs (A) beside the opening on
the left side of the housing. See Figure 6.
2. Remove the two hex bolts, lock nuts, and flat
washers from the two holes on the upper end of
the brace.
,
Place the chipper chute over the weld studs so
the slot on the chute is towards the bottom. Align
the three holes on the chute with the three weld
studs.
Figure 7
Loading ...
Loading ...
Loading ...