Loading ...
Loading ...
Loading ...
9
ENGLISH
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can causeinjury.
Installing and Removing the Battery Pack
(Fig. E)
NOTE: For best results, make sure your battery pack is
fullycharged.
To install the battery pack
1
into the tool handle, align the
battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does notdisengage.
To remove the battery pack from the tool, press the release
button
2
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of thismanual.
Fig.E
1
2
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the main
handle
3
and one hand on the battery pack. Hold tool
firmly with both hands to control the twisting action of
thedrill.
Fig.F
3
Variable Speed Trigger Switch and
Forward/Reverse Control Button (Fig. G)
The drill is turned ON and OFF by pulling and releasing the
trigger switch
4
. The farther the trigger is depressed, the
higher the speed of the drill.
A forward/reverse control button
5
determines the
rotational direction of the tool and also serves as a
lock-offbutton.
• To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool.
• To select reverse, depress the forward/reverse control
button on the left side of the tool.
NOTE: The center position of the control button locks the
tool in the off position. When changing the position of the
control button, be sure the trigger is released.
NOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
beavoided.
Fig.G
5
4
LED Work Light (Fig. A)
CAUTION: Do not stare into worklight. Serious eye
injury could result.
The worklight
8
is activated when the trigger switch
4
is
depressed, and will automatically turn off approximately 20
seconds after the trigger switch is released.
NOTE: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
WARNING: When the torque adjustment collar is
in the drill or hammerdrill position, the drill will not
clutch. The drill may stall if overloaded, causing a
sudden twist.
Symbol Mode
Drilling
1–15 Screwdriving (higher number = greater torque)
Hammerdrilling (DCD709 only)
Loading ...
Loading ...
Loading ...