Loading ...
Loading ...
Loading ...
28
IS THERE A PROBLEM ?
PROBLEMS POSSIBLE CAUSES SOLUTIONS
There is no steam. The appliance is not
plugged in, or not
switched on.
Check that your appliance is correctly
plugged in and switched on.
The water level is too low. Unplug your appliance and rell it.
The steam pump has not
been primed.
Press the steam trigger continuously
for a few seconds to begin steaming.
You are using the appli-
ance for the rst time.
Press the steam trigger continuously
for a few seconds to begin steaming.
The water tank is not fully
in place.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
The appliance
does not heat.
It is not plugged in, or not
switched on.
Plug in your appliance and switch on.
Water leaks. The water tank is not fully
in place or the stopper is
not closed properly.
Ensure that stopper is closed and that
the water tank snaps when put into
place.
Steam rate
decreases.
Calc Sealing. Refer to ‘ANTI CALC section in instruc-
tions for use.
The steam leaves
stains on the fabric
or the appliance
spits.
You are using water with
additives.
Never add any additive in the water
tank.
The appliance has not
been cleaned enough after
the descaling operation.
Read carefully the ‘ANTI CALC’ section
in instructions for use.
You are using other liquids
than white vinegar to
descale the product.
Use only white vinegar during ‘ANTI
CALC’ procedure.
Appliance steams
continuously.
The steam trigger is on the
lock position.
Unlock the steam trigger.
There is not
enough power or
too much.
The dual voltage is not set
correctly.
Ensure that the dual voltage selector is
in correct voltage position before oper-
ating. Unplug the appliance and switch
the selector to the correct voltage.
Loading ...
Loading ...
Loading ...