Loading ...
Loading ...
Loading ...
9
5.0 Unpacking
Open shipping container and check for shipping damage; report any damage immediately to your distributor and
shipping agent. Do not discard any shipping material until the Lathe is assembled and running properly. Compare
the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any,
should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and
safety instructions.
5.1 Contents of shipping container
Referring to Figure 1:
1 Lathe (not shown)
1 7-1/4” Four-Jaw Independent Chuck (A)
1 Faceplate (B)
1 4” Three-Jaw Universal Chuck (pre-mounted)
1 Four Way Tool Post (pre-mounted)
1 Steady Rest (pre-mounted)
1 Follow Rest (pre-mounted)
1 Operator's Manual (not shown)
1 Product Registration Card (not shown)
2 Chuck Reversing Jaws, Set of 3* (F)
1 MT-2 Center* (H)
1 MT-3 Center* (I)
1 56T Gear (pre-mounted)
1 52T Gear* (J)
1 48T Gear* (K)
1 46T Gear* (L)
1 45T Gear* (M)
1 44T Gear* (N)
1 40T Gear* (O)
1 38T Gear* (P)
2 32T Gear* (Q)
1 30T Gear* (R)
1 28T Gear (pre-mounted)
1 Tension Roller Lever* (S)
1 Handle* (T)
1 Female Chuck Key* (U)
2 Male Chuck Keys* (V)
1 #1 Cross Point Screwdriver* (W)
1 #1 Flat Blade Screwdriver* (X)
1 5pc Hex Wrench Set (Y)*
1 4mm T-Handle Hex Wrench* (not shown)
2 Open End Wrenches – 8/10mm, 12/14mm* (Z)
* parts marked with an asterisk are included in the tool box, stock no. BDB919-TBC
Read and understand the entire contents of this manual before attempting set-up or
operation! Failure to comply may cause serious injury.
CAUTION
The three jaw chuck and the face plate have a set screw on their flanges that secures them to the
threaded spindle. Before removing the three jaw chuck or the faceplate, remove the set screw
completely from the flange. Failure to remove the set screw may cause damage to the threads on
the spindle. When installing either the jaw chuck or the faceplate, tighten the set screw firmly to
prevent the chuck or the faceplate from coming off the spindle during operation.
Figure 1
Loading ...
Loading ...
Loading ...