Loading ...
Loading ...
Loading ...
12 13
USING YOUR ICE MAKER TROUBLE SHOOTING
1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the water level mark.
2. Press “ON/OFF” button on the control panel to begin the ice
making cycle.
3. Select the ice cube size by pressing the “SELECT” button. If the
room temperature is lower than 60
O
F, it is recommended to select
small ice cube in order to avoid ice sticking together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending
on selection of ice cube size and the room temperature. The
recommended room temperature is 50
O
F to 105
O
F.
5. If water pump can’t inject water, the ice maker will stop
automatically, and the “ADD WATER” indicator will be on. Press
“ON/OFF” button, fill water up to the max. water level mark and
press “ON/OFF” button again to turn on the unit again. Allow the
refrigerant liquid inside the compressor at least 3 minutes to settle
before restarting.
6. The ice maker stops when the ice basket is full and the “ICE
FULL” indicator will be on. Warning: Direct sunlight or sunlight
reflection may cause infrared sensor malfunction. If the unit
doesn’t stop even ice cubes obstruct sensor, move the unit to the
place where there is no sunlight.
7. Change water in the water reservoir every 24 hours to ensure a
reasonable hygiene level.
If unit isn’t to be used, drain all the water and dry the tank.
PROBLEM POSSIBLE CAUSE SOLUTION
Stop the ice maker,
fill water, and press
“ON/OFF” button
again to restart the
unit.
Remove ice from ice
basket. Keep
pressing “Select”
button for 5 seconds,
the unit could make
ice 10 cycles even
“Ice” indicator is on.
Stop the ice maker,
and restart it when
the ice blocks melt.
Select the small size
ice cube selection.
Replace the water.
Temperature of water
recommended at
40
O
F-90
O
F
The room
temperature should
be 50
O
F -105
O
F, water
temperature should
be 40
O
F-90
O
F.
Verify by a qualified
technician.
Verify by a qualified
technician.
Lack of Water.
Ice is full in basket.
The ice making cycle
is too long.
Water temperature in
inner tank is too low.
Room temperature or
water temperature in
inner tank is too high.
Refrigerant in cooling
system leaks.
Pipe in the cooling
system is blocked.
“ ADD WATER ”
indicator is on.
“ICE FULL”
indicator is on.
Ice cubes
stick together.
Ice making cycle
is normal but
no ice formed.
Loading ...
Loading ...
Loading ...