Loading ...
Loading ...
Loading ...
5
IMPORTANT SAFETY INSTRUCTIONS
• Prior to use, clean the interior surface with warm water using a soft cloth.
• The door on this appliance is designed so it may be opened from either the left or the
right side. The unit is delivered with the door opening on the left side and swinging
out to the right. Should you wish to open the door from the right, see the installation
manual.
INSTALLATION OF YOUR APPLIANCE
Do not store or install the appliance outdoors.
WARNING
• Wine coolers and beverage coolers are designed for either built-in or free-standing
installation.
• Place your unit on a floor that is strong enough to support it when it is fully loaded.
Please note the units weigh roughly 136 to 144 pounds when empty, so adjust
accordingly.
• To level your appliance, adjust the 4 legs by twisting clockwise or counter-clockwise
as needed until level.
• Install the appliance indoors and away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Sunlight may affect the acrylic coating, and heat
sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly.
• Never install the unit in damp or overly humid areas.
• Any questions concerning power and/or electrical connection should be directed
toward a qualified electrician, technician, or service provider.
• The air vent located at the bottom front of the appliance must never be covered or
blocked in any way.
• The unit must be appropriately installed to all electrical connections in accordance
with state and local government codes.
• Please note that the cooler may experience decreased cooling efficiency if air flow is
restricted due to a fully loaded cabinet.
• Install the wine cooler or beverage cooler in a well-ventilated area where the
ambient temperature is above 50° F and below 90° F.
General Safety
Loading ...
Loading ...
Loading ...