Loading ...
Loading ...
Loading ...
2. 2
.
°
Slide the Front Upright (42) onto the 5/16" x
2 1/2" Carriage Bolts (1). Hand-tighten a 5/16"
Nylon Locknut (3) onto each Carriage Bolt.
Do not tighten the Nylon Locknuts yet.
Press a 1" Square Inner Cap (65) into the
Front Upright (42).
Press a 2" Square Inner Cap (27) into each
end of the Top Frame (55). Press a 1 3/4"
Square Inner Cap (44) into each end of the
crossbar on the Top Frame. Press two 1"
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Upright
(42) and the Rear Upright (56) with four 5/16"
x 2 3/4" Bolts (11), four 5/16" Flat Washers
(8), and four 5/16" Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1
through 3,
Set two Weight Bumpers (19) onto the bracket
on the Base (4) as shown.
Stack six Weights (25) onto the Weight
Bumpers (19). Be sure that the pin grooves
are all on the same side and that the "wel-
der" logo is on top.
3
65
11
44..._ i \ "+=
Crossbar
3_42 '
_1_ Pin Groove
4--Brac
Loading ...
Loading ...
Loading ...