Loading ...
Loading ...
Loading ...
1. SJiding nozzJe forward and back adjusts spray
pressure.
Slide nozzle backward for Slide nozzle forward for low
high pressure mode. pressure mode and
detergent application,
2. Point nozzle toward ground, disengage safety
latch, and press trigger to test pattern.
3. Rotating nozzle adjusts spray pattern from a
narrow pattern to a fan pattern.
Twist nozzle counter-
clockwise for fan pattern.
Twist nozzle clockwise for
narrow spray pattern,
.
For most effective cleaning, keep spray nozzle
between 8 to 24 inches away from cleaning
surface.
5. if you get spray nozzle too close, especially using
high pressure mode, you may damage the surface
being cJeaned.
6. DO NOT get closer than 6 inches when cleaning
tires.
Applying Detergent with Adjustable Nozzle
JIVtPORTANT: Use chemicals designed specificalJy for
pressure washers. Household detergents could
damage the pump.
CAUTtON
Starting the engine without al! the hoses connected and
without the water turned ON wil! damage the pump,
Damage to equipment resulting from failure to follow this
instruction will void warranty,
To apply detergent, follow these steps:
1. Review use of adjustabJe nozzJe.
2. Prepare detergent solution as required by job.
3. Place fiJter end of detergent siphoning tube into
detergent container.
CAUTION
* When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently
contacting the hot muffler.
4. Slide adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with nozzJe in
high pressure position.
5. Make sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump. Start engine.
6. Apply detergent to a dry surface, starting from
bottom and working up.
7. AlJow detergent to "soak in" for 3z5 minutes before
rinsing. Reapply as needed to prevent surface
from drying.
8. For washing, start at lower portion of area to be
washed and work upward, using long, even,
overlapping strokes.
iMPORTANT: You must flush the chemicaJ injection
system after each use by placing the filter into a clean
bucket of water and running the pressure washer in
low pressure for 1z2 minutes.
10
Loading ...
Loading ...
Loading ...