RCF TT 5-A II DATASHEET

Loading ...

ENGLISH

At this point you can connect the power supply cable and the signal cable, but before turning

on the speaker make sure that the volume control is at the minimum level (even on the mixer

output). It is important that the mixer is already ON before turning on the speaker. This will avoid

damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a

good practice to always turn on speakers at last and turn them off immediately after the show.

Now you can turn ON the speaker and adjust the volume control to a proper level.

BEFORE TURNING ON

THE SPEAKER

WARNING: daisy chaining speakers always make sure that the maximum current

requirement does not exceed the maximum admitted POWERCON current. In case of doubt

call the closest RCF SERVICE CENTRE.

INSTALLATION

WARNING

The fuse settings/replacement shall be as follow:

TT1-A II

230 Volt, 50 Hz SETUP : FUSE VALUE T 3.15 A H 250 V

115 Volt, 60 Hz SETUP : FUSE VALUE T 6.30 A H 250 V

TT2-A II / TT5-A II

230 Volt, 50 Hz SETUP : FUSE VALUE T 6.30 A H 250 V

115 Volt, 60 Hz SETUP : FUSE VALUE T 10.0 A H 250 V

SERVICE NOTE

VOLTAGE SETUP

(RESERVED TO THE RCF SERVICE CENTRE)

Loading ...

RCF TT 5-A II ACTIVE TWO-WAY SPEAKER