Loading ...
Loading ...
Loading ...
10
figure N) in the housing. Rotate the spool slightly
until it is seated. The line should protrude approximately from the housing.
figure O).
CAUTION: To avoid trimmer damage, if the cutting line protrudes beyond the trimming
blade, cut it off so that it just reaches the blade.
REWINDING SPOOL FROM BULK LINE (USE ONLY .065 IN. ROUND DIAMETER LINE)
Bulk line is also available for purchase from your local retailer. NOTE: Hand wound spools
from bulk line are likely to become tangled more frequently than BLACK+DECKER factory
wound spools. For best results, factory wound spools are recommended.
To install bulk line, follow the steps below:
trimmer.
trimmer as described in “REPLACING THE SPOOL”.
line into one of the line anchoring slots (21) as shown in figure P.
as shown in figure Q. Make sure the line is pulled tight against the spool as shown in figure Q.
the direction of the arrow on the spool. Make sure to
wind the line on neatly and in layers. Do not crisscross (figure R).
the recesses (23), cut the line. (figure Q).
trimmer as described in “REPLACING THE SPOOL”.
THE RBRC™ SEAL
battery (or battery pack) indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid by BLACK+DECKER.
RBRC™ in cooperation with BLACK+DECKER and other battery users, has established
our environment and conserve natural resources by returning the spent LI-ION battery to an
authorized BLACK+DECKER service center or to your local retailer for recycling. You may
also contact your local recycling center for information on where to drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
MAINTENANCE
WARNING: To avoid serious injury, remove the battery from the trimmer before
performing any maintenance.
CAUTION:
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition, store spare pre-
wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.
periodically touch-up the sharpness of the blade with a file.
TROUBLESHOOTING
TRIMMER RUNS SLOWLY
Check that the spool housing can rotate freely. Carefully clean it if necessary.
approximately
from the spool. If it does, cut it off so that it just reaches the line trimming blade.
AUTOMATIC LINE FEED DOES NOT WORK
Remove the spool cap.
approximately
insufficient cutting line is left on the spool, install a new spool of cutting line.
figure R. If it is, unwind
the cutting line, then wind it back on the spool neatly so that the lines do not cross.
Ensure the beginning of the cutting line is pulled tight against the spool as shown in figure Q.
Loading ...
Loading ...
Loading ...