Loading ...
Loading ...
Loading ...
– 2 –
1/General Guide
k About the Selectors
Rounding Selector
Specifies the rounding system.
F: Floating decimal point system, which displays the value without rounding.
CUT: Cuts off the decimal to the specified* number of places.
UP: Rounds up the decimal to the specified* number of places.
5/4: Rounds off the decimal to the specified* number of places.
* Use the Decimal Place Selector to specify the number of decimal places.
Decimal Place Selector
Specifies the number of decimal places for rounding. Note that the Decimal Place
Selector is valid whenever the Rounding Selector is in any position other than F.
4, 3, 2, 1, 0: Number of decimal places for the CUT, UP and 5/4 settings of the
Rounding Selector.
ADD
2
: The ‘‘Add Mode’’ automatically adds a decimal point and two decimal places
to all values, even if you don’t input a decimal point. This mode is very useful
when performing calculations in dollars or other monetary systems that
require two decimal places. Two decimal places are not added in this mode if
you press the . key while inputting a value, or for any operation other than
addition and subtraction.
k About the Display
⬘
: 3-digit separator (apostrophe)
GT : Grand total memory indicator
M:Independent memory indicator
E:Error indicator
–:Negative value indicator
K:Constant calculation indicator
TAX : Tax amount indicator
TAX+ : Price-plus-tax indicator
TAX– : Price-less-tax indicator
DS-120TV_E_0620.p65 17.7.28, 15:512
Loading ...
Loading ...
Loading ...