Loading ...
Loading ...
Loading ...
APY34636—UN—06APR20
2. Lift up on (A) on right side of seat.
3. Lean forward and slide seat forward or rearward to desired position.
Do not lean back on top of seat to push rearward.
4. Release seat adjustment lever to lock in position.
Lumbar Seat Adjustment (If Equipped)
● Turn lumbar seat adjustment dials (B) on either side of seat to
adjust rmness of seat.
SR99263,0000314-19-30JUN20
Adjusting Cutting Height
Cutting height is adjusted from approximately 25—100 mm (1—4 in.)
in 6.4 mm (1/4 in.) increments. When mower deck is in transport
position, cutting height is approximately 100 mm (4 in.).
Detents allow the adjustment lever to be positioned at each indicated
mower setting, as well as the mid-point between each setting.
Mower Setting Approximate Cutting Height
1 25 mm (1 in.)
– 32 mm (1-1/4 in.)
– 38 mm (1-1/2 in.)
2 50 mm (2 in.)
– 57 mm (2-1/4 in.)
– 65 mm (2-1/2 in.)
– 70 mm (2-3/4 in.)
3 75 mm (3 in.)
– 83 mm (3-1/4 in.)
– 90 mm (3-1/2 in.)
– 95 mm (3-3/4 in.)
4 (Transport) 100 mm (4 in.)
1. Put attachment lift lever into the slot near desired cutting height.
2. Adjust mower deck wheels.
Transporting or Getting On and O Machine
● Pull attachment lift lever all the way back to transport position or
100 mm (4 in.) cutting height.
JS86122,00003BF-19-12AUG14
Checking and Adjusting Mower Deck Level
CAUTION: Avoid injury! Rotating blades are dangerous.
Before adjusting or servicing mower:
● Disconnect spark plug wires or battery negative (-) cable
to prevent engine from starting accidentally.
● Always wear gloves when handling mower blades or
working near blades.
NOTE: Mower deck wheels should not contact the ground when
leveling the mower deck.
Method One
1. Make sure machine is on a at, level surface.
2. Park machine safely. (See Parking Safely in the Safety section.)
3. Check that tires are inated to correct tire pressure. Tire pressure is
marked on the side of the tire.
4. Raise deck to highest position.
APY18570—UN—10JUL20
42 in (107 cm) Mower Deck is Shown.
5. Place three short 51 mm (2 in) blocks of wood under the edges (A)
of the mower deck.
6. Lower mower deck to the 63 mm (2.5 in) cutting height position.
For S130 models, lower deck to 57 mm (2-1/4 in) cutting height
position.
7. Check that the mower deck is level and lightly touching each of the
three wooden blocks.
APY36153—UN—24JUL20
● If the rear of the mower deck is not touching the rear blocks, or is
sitting heavily on the blocks, adjust the rear lift links by turning
the leveling nut (B) on each lift link. The blocks should be able to
easily slide in and out beneath the mower deck when the mower
deck is correctly adjusted.
Operating
18
Loading ...
Loading ...
Loading ...